Quick Start Manual

50
Chapter 4: Installing Components
www.gateway.com
7 While holding the handle, press the power supply release lever with your
thumb, then pull the power supply out of the server.
8 Insert the new power supply into the vacant slot, then press it all the way
in until it is flush with the front of the server.
9 Fold the power supply handle against the face of the power supply, then
tighten the screw. The screw does not have to be tightened for the power
supply to function correctly.
Warning Do not try to move or lift the server by the power supply
handles.
Warning If you are not installing a replacement module, you must
install a power supply slot cover to maintain correct air flow
and cooling. For instructions, see “Adding a redundant
power supply” on page 51.