Owner's Manual
Table Of Contents
- Contents
- Checking Out Your Gateway E-4100 Computer
- Setting Up Your Computer
- Getting Help
- Using Drives and Multimedia
- Maintaining Your Computer
- Restoring Software
- Upgrading Your Computer
- Using the BIOS Setup Utility
- Troubleshooting
- E-4100 Technical Reference
- Safety, Regulatory, and Legal Information
- Index
143
Gateway Micro Tower Case
www.gateway.com
9 Slide the system board toward the front of the case, then up and out of
the case. The system board standoffs slide out of the keyhole slots.
10 Slide the new system board into the keyhole slots and lock it into place
with the thumbscrew.
11 Reconnect the power and data cables using your notes from Step 4. See
the system board documentation for further instructions.
12 Reinstall the add-in cards by following the instructions in “Adding or
replacing add-in cards” on page 136.
13 Close the case by following the instructions in “Closing the case” on
page 127.
Important The new system board must have special standoffs
(pem studs) mounted on the bottom of the board. If
necessary, use the standoffs from the original system
board.