SuperLoader 3 Models E-824R, E-826R User Guide

CHAPTER 3: Operating your Autoloader www.gateway.com
42
Ejecting a magazine
When you want to remove several cartridges at once, eject the magazine(s) first.
To eject a magazine:
1 From the Main menu, scroll to Commands, then press ENTER. The
Commands submenu opens.
2 Scroll to Eject, then press ENTER. The Eject submenu opens.
3 Scroll to Right Magazine or Left Magazine, then press Enter.
You should hear a distinctive popping sound as the appropriate magazine
is ejected from the autoloader. “Left magazine has been ejected” or “Right
magazine has been ejected” appears on the LCD.
Caution
To prevent damage to the autoloader or
the magazine, use both hands to support
the entire length of the magazine when
removing a magazine.
4 Grasp the magazine by the handle with one hand and slide it out,
supporting it underneath with the other hand.
After you eject a magazine, you must fully remove it or fully reinstall it
before powering off the autoloader. Before returning a magazine to the
autoloader, manually turn the wheels on the side of the magazine. If they
move freely, the cartridges are correctly seated. If the wheels do not turn
freely, check the cartridges and remove or replace as needed.
Magazine Load/Unload command
When issuing a Load/Unload command to the autoloader, the system
automatically ejects the right magazine.
To remove the left magazine using the Load/Unload command:
1 Remove the right magazine.
2 Replace the right magazine with a magazine blank.
3 Issue the Load/Unload command again. The system then ejects the left
magazine.
4 If you want to put the magazine in the right bay, replace the magazine
blank in the right bay with a cartridge magazine.
Installing a magazine
To install a magazine into the autoloader:
1 Grasp the magazine by the handle with one hand and support it
underneath with the other hand.
2 Slide the magazine into the magazine bay until it clicks.
Make sure that you position the magazine correctly. It should slide into
the magazine bay smoothly. If you meet resistance, make sure that the
magazine is correctly oriented.