Owner's Manual

www.gateway.com
35
14 Secure the assembly by tightening the thumbscrew you previously loosened.
15 Attach the 44-pin optical drive cable to the back of the optical drive interface board.
16 Reinstall the large fan cage by following the instructions in “Replacing system fans” on
page 44.
17 Follow the instructions in “Closing the server case” on page 32.
18 Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
19 Reconnect all power cords and peripheral device cables, then turn on the server.
Removing and installing a tape drive
To remove and install a tape drive:
1 Follow the instructions in “Preventing static electricity discharge” on page30. Make sure
that you turn off the server, then unplug the power cord(s) and all other cables connected
to the server.
2 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3 Follow the instructions in “Opening the server case” on page 31.
4 Remove the large fan cage by following the instructions in “Replacing system fans” on
page 44.
5 Disconnect the data and power cables from the tape drive.
6 Loosen the thumbscrew (1) holding the media cage in the chassis, then push the
assembly (2) out the front of the chassis.
Caution
The tape drive is not hot-swappable. Before installing or removing the drive,
make sure that power is turned off and the power cord(s) is unplugged.