Owner’s Manual KAS-103 System KAS-203 System SW203 Subwoofer SP303 2 Rear Satellites SW103 Subwoofer SP103 2 Rear Satellites CC103 Center SP303 2 Front Satellites CC303 Center SP103 2 Front Satellites KAS-303 System SW303 Subwoofer SP303 2 Rear Satellites CC303 Center Video-Shielded Home Theater Speaker Systems by Designed and engineered in the U.S.A.
IMPORTANT SAFETY INSTRUCTIONS 2 The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
A B UNPACKING PLACEMENT Carefully remove your new Gateway® speakers from their boxes, avoiding staples which can cause damage to the cabinets. Inspect each speaker for transit damage. If you discover damage, contact Gateway® immediately. Positioning Your Subwoofer See the subwoofer owner’s manual. Save your cartons – they are the best possible protection for your speakers should you ever have a need to move them. Positioning Your Satellites Refer to Figure 1 for satellite speaker placement.
same height as the two surround speakers, but centered on the wall between them. It may take some experimentation with different locations for the surround speakers to suit your preference and your room. The center channel speaker should be placed as close to the TV as possible, preferably directly above or below the set. 4 Each satellite is supplied with a mounting bracket to allow hanging the speaker system on the wall.
Setting Up Your New KAS-103, KAS-203, or KAS-303 System Speakers KAS-103 SETUP CAUTION: Make sure that you consult your amplifier’s owner’s manual regarding speaker setup. Your amplifier should be turned off throughout this procedure. IMPORTANT: Make certain all stereo system components including the subwoofer are turned OFF before proceeding. C SETUP Refer to Figure 4 for proper connection. Use the supplied male RCA to RCA line level cable to connect the subwoofer to the receiver.
KAS-203, KAS-303 Setup IMPORTANT: Make certain all stereo system components including the subwoofer are turned OFF before proceeding. Refer to Figures 5 and 6 for proper connection. Use the supplied male RCA to RCA line level cable to connect the subwoofer to the receiver. The satellites connect to the receiver as shown with the red/black wires supplied with your system. Be sure to maintain proper polarity when connecting the satellites and center.
SP303 Left Rear Satellite SP303 Center Rear Satellite SP303 Right Rear Satellite 7 SW303 Subwoofer CC303 Center Note: Switch in the UP position to turn "Ventriloquist" function ON CC303 Designed & engineered in the U.S.A. Made in China #7004675 SP303 Right Front Satellite SP303 Left Front Satellite Surround Sound Receiver RCA Line Cord Figure 6: KAS-303 Setup D INITIAL LISTENING TEST o 1. Double-check all connections. o 2.
o 6. Some digital receivers only send a subwoofer out signal when playing a DVD or movie in the digital mode. In the 2-channel (stereo music) mode, no subwoofer out signal is sent to the subwoofer. You may need to set your main speakers to “small” mode in your receiver setup to get the receiver’s subwoofer out to turn on. Check your receiver’s owner’s manual for setup and subwoofer operation. o 7. Adjust the subwoofer’s VOLUME control until you are satisfied with the amount of bass.
