DVD Player User Manual
Table Of Contents
- Contents
- Checking Out Your Gateway Receiver
- Connecting Components and Speakers
- Understanding video connections
- Understanding audio connections
- Connecting the AM loop antenna
- Connecting the FM antenna
- Connecting a DVD player
- Connecting a 6 or 7 channel component
- Connecting a VCR
- Connecting a tape component
- Connecting an AUX component
- Connecting a television
- Connecting speakers
- Plugging in your components
- Using the Receiver
- Using the OSD
- Maintaining and Troubleshooting Your Receiver
- Specifications and Setup Codes
- Safety, Regulatory, and Legal Information
- Index
40
Chapter 3: Using the Receiver
www.gateway.com
Yes / None — Select Yes if a subwoofer is connected. Select None if a subwoofer
is not connected.
■ See the specifications of the speakers that you are connecting. For example,
if the frequency range of your speakers is 80 Hz ~ 12 KHz, then the
Crossover Frequency is 80 Hz.
■ If you do not know the specifications for your speakers, try comparing the
sound at both settings (set the volume to a low level so you do not damage
the speakers) to determine the correct setting.
■ Depending on how you set your speakers, not all options may be available
to you. For example, if you set your Front L/R speakers to
Large, you will
have
Large, Small, and None as options for your Center speaker. But if you
set your Front L/R speakers to
Small, the only options available for your
Center speaker will be
Small and None.