DVD Player User Manual
Table Of Contents
- Contents
- Checking Out Your Gateway Receiver
- Connecting Components and Speakers
- Understanding video connections
- Understanding audio connections
- Connecting the AM loop antenna
- Connecting the FM antenna
- Connecting a DVD player
- Connecting a 6 or 7 channel component
- Connecting a VCR
- Connecting a tape component
- Connecting an AUX component
- Connecting a television
- Connecting speakers
- Plugging in your components
- Using the Receiver
- Using the OSD
- Maintaining and Troubleshooting Your Receiver
- Specifications and Setup Codes
- Safety, Regulatory, and Legal Information
- Index
55
Surround sound
www.gateway.com
Adjusting the tone
You can adjust the tone (bass and treble).
To adjust tone:
1 Press the SETUP button on the receiver for more than 2 seconds to enter
Setup mode.
2 While in Setup mode, repeatedly press the SETUP button on the receiver
until
TONE OFF or BASS appears.
3 While displaying BASS, press the DECODING button on the receiver to cycle
between the available modes:
BASS, TRBL, and TONE ON.
4 While displaying the tone mode you want, press the ADJUST up and down
buttons on the receiver to adjust the tone.
You can also adjust the tone settings using your remote control and the OSD.
For more information, see “OSD menus and options” on page 66.
Compressing the dynamic range
You can adjust the compression of Dolby Digital program sources to minimize
the volume difference between high and low levels. This feature is useful if you
are listening to Dolby Digital program sources at low volume levels. This feature
can only be used for Dolby Digital program sources.
To compress the dynamic range of Dolby Digital program sources:
1 Press the SETUP button on the receiver for more than 2 seconds to enter
Setup mode.
2 While in Setup mode, repeatedly press the SETUP button on the receiver
until
DYNR 0.0 appears.