user manual

Wireless Cable Modem Gateway CGD24G User Manual
2-20 Wireless Configuration
v1.1, May 2009
By default, the Access List table is empty. You must add wireless clients so that they will have
access to the wireless network when the list is enabled.
5. Adjust the access list as needed for your network. You can add devices to the access list using
either one of the following methods:
• If the computer is in the Connected Wireless Devices table, click the radio button of that
computer to capture its MAC address. Then click Add.
• Enter the MAC address of the device to be added in the Add Access Filter fields. The
MAC address can usually be found on the bottom of the wireless device. Then click Add
.
6. Click Apply to save these settings. Now, only devices in the Access List table will be allowed
to wirelessly connect to the gateway.
Figure 2-11
Note: If no Device Name appears when you enter the MAC address, you can type a
descriptive name for the computer that you are adding.