user manual

Wireless Cable Modem Gateway CGD24G User Manual
5-6 Customizing Your Network
v1.1, May 2009
– End Port. Enter the start port for the trigger range.
• Target Range. The target range consists of the range of incoming ports that will be
opened when triggered:
– Start Port. Enter the start port for the target range.
– End Port. Enter the start port for the target range.
• Protocol. Select the protocol for the ports,:
– TCP. Select TCP only.
– UDP. Select UDP only.
– Both. Select both TCP and UDP.
• Select the Enable check box to activate the port trigger.
3. Perform one of the following actions:
• Click Apply to save your settings and activate the port triggers that you have enabled in
step 2.
• Click Delete to remove a port trigger that you can select by clicking the radio box next to
the port trigger that you want to delete.
• Click Reset to return all trigger and target ranges to their default values of zero.
Setting Up a DMZ Host
You can use the DMZ Host screen to set the gateway to respond to a ping and specify a DMZ
address. To configure a default DMZ host:
1. In the main menu, under Advanced, select DMZ Host. The DMZ Host screen displays.
Figure 5-4