User Guide

47
Replacing the LCD panel assembly
www.gateway.com
12 Slide the LCD panel all the way up again, then remove the four screws
that secure the hinge to the LCD panel.
13 Lift the LCD panel straight up and off the hooks.
14 Place the new LCD panel onto the hinge so the panel’s hooks engage the
slots on the hinge plate.
15 Secure the LCD panel to the hinge plate with the four screws you removed
previously.
16 Thread the two video cables through the hole in the top center of the
chassis, then plug the cables into the system board.
17 Tighten the reusable cable ties to secure the video cables to the top of the
chassis.
18 Slide the LCD panel down about an inch.
19 Press the LCD hinge plate cover’s tabs into the corresponding slots on the
LCD panel, then slide the cover to the right until it locks into place.
20 Snap the LCD hinge cover onto the hinges.
Screws Screws
Then slide the cable into this locking slot.
Insert the cable loop into this hole.