- One Gateway Computer Reference Guide

www.gateway.com
15
Connecting power
To connect power:
1 Plug your computer’s power/data cable into the
power/data connector on the power module. Make sure
that the cable’s clips lock into place.
2 Plug the provided AC power cable into the power
module, then plug the power cable into an ACpower
outlet. We recommend using a surge protector.
3 To disconnect the power/data cable from the power
module, press inward on the two connector latches, then
pull the plug away from the module.
8512740.book Page 15 Thursday, September 27, 2007 2:43 PM