- One Gateway Computer Reference Guide

CHAPTER2: Setting Up and Getting Started

Installing mouse batteries

Before using your mouse, you must install the two batteries

that came with it.

To install the mouse batteries:

1 Turn the mouse over and remove the battery cover (if

installed) by prying it up using a thin object (such as your

fingernail).

2 Insert two AA batteries according to the diagram inside

the battery compartment, then install the battery cover.

3 Your wireless mouse is synced with your computer at the

factory. However, if the mouse does not work after

installing new batteries, re-sync the mouse with the

computer by following the instructions in “Syncing the

keyboard and mouse” on page 22.

Warning

Danger of explosion if battery is incorrectly replaced. Replace only with the

same or equivalent type recommended by the manufacturer. Dispose of used

batteries following the manufacturer’s instructions.

Pry up here

8512740.book Page 18 Thursday, September 27, 2007 2:43 PM