- One Gateway Computer Reference Guide

CHAPTER3: Upgrading Your Computer

4 Lift the end of the graphics card or spacer to about a 30°

angle, then slide it out of the card slot.

5 Slide the new graphics card into the card slot at a 30°

angle, then secure it to the computer using the two

screws you removed previously.

6 Close the back panel by following the instructions in

“Opening and closing the case” on page 46, then

reconnect all cables.

Changing the system battery

If the computer clock does not keep time or the settings in the

BIOS Setup utility are not saved when you turn off your

computer, replace the system battery. Use a battery of the

same size and voltage as the original battery that was in your

computer.

To replace the battery:

1 Restart your computer.

2 During the restart, press and hold the F2 key. The main

menu of the BIOSSetuputility opens.

Warning

Danger of explosion if battery is incorrectly replaced. Replace only with the

same or equivalent type recommended by the manufacturer. Dispose of used

batteries following the manufacturer’s instructions.

8512740.book Page 56 Thursday, September 27, 2007 2:43 PM