User's Manual

ADAC Ultra2 S466 Hardware Guide
96
G
GWC, 90
H
Hardware Installation, 53
Hardware Requirements, 30
High-Density 68-Pin SCSI
Connector and P-Cable
Single-Ended Cable
Pinouts, 91, 93
High-Density Connector, 92
Host-Based RAID Solution, 7
Hot Spare, 13, 16
Using during disk rebuild, 14
Hot Swap, 15, 39
I
Improved I/O, 5
Increased Reliability, 5
Install Drivers, 70
Installation
Custom, 54
J
J 4 Channel 1 WIDE (16-bit) SCSI
connector, 58
J1 Termination Enable, 59
J2, 66
J3 I2C Interface Connector, 59
J4 Serial Port, 59
J5 Disk Activity LED Connector, 59
J6, 66
J7 SIMM socket, 57
J8, J9, J10, 60
J11, J12 i960RP Initialization, 60
J13, 58
J15, 58
Jumpers, 58
on motherboard, 55
L
Logical Drive, 15
Logical Drive States, 16
M
ADAC BIOS Setup, 38
ADAC Ultra2 S466 Card Layout,
58
ADAC Configuration Manager, 38
Mirroring, 11
Motherboard Jumpers, 55
Multi-threading, 37
N
Nonvolatile RAM, 34
Novell NetWare, 33
O
Offline, 16
Onboard Speaker, 36
Online
Drive state, 16
Operating Systems Supported, 33
Operating Voltage, 34
Optimal, 16
OS/2 2.x, 38
Other BIOS Error Messages, 77
P
Package Contents, vi
packing slip, vi
Parity, 12
PCI Controller, 34
Physical Array, 14
Physical drive, 14
Power Console Plus, 38
Power Down, 55
Processor, 34
Product Specifications, 34
R
RAID
Basics, 5
Benefits, 5
Introduction to, 5
RAID 1
Spanning to configure RAID 10,
10
RAID 10
Configuring, 10
RAID 3
Parity disk, 12
Spanning to configure RAID 30,
10
RAID 30
Configuring, 10
RAID 5
Spanning to make RAID 50, 10
RAID 50