Instructions for use

ManualsBrandsGAUI ManualsFPV Racing - Shooting - action camTransmitter GUEC GV-100TX

MADE IN TAIWAN

v1.4

我們建議您從GAUI官方網站的下載區，

下載並使用最新的手冊。

Website: www.gaui.com.tw

We recommend downloading and using the

latest Manual from Official GAUI website's

download area.

System Manual

GV-100

GAUI

www.gaui.com.tw

E-mail: gaui@gaui.com.tw

TEL: +886-2-86305567

FAX: +886-2-26105567

No.118, Ren’ai Rd., Bali Dist.,

New Taipei City 249, Taiwan

Summary of content (4 pages)

PAGE 1
v1.4 GV-100 System Manual GAUI www.gaui.com.tw E-mail: gaui@gaui.com.tw TEL: +886-2-86305567 FAX: +886-2-26105567 No.118, Ren’ai Rd., Bali Dist., New Taipei City 249, Taiwan We recommend downloading and using the latest Manual from Official GAUI website's download area. 我們建議您從GAUI官方網站的下載區，下載並使用最新的手冊。 Website: www.gaui.com.
PAGE 2
Hardware description 硬體介紹 Cabling descriptions 接線圖 ------------- P.1 --------------- P.2 Monitor OSD function description 畫面功能說明 --- P.3 Radio Adapter for Receiver/LCD module. 固定架安裝圖 GV-100TX Installation GV-100TX 安裝 --- P.4 Switching between NTSC & PAP system 信號格式(NTSC & PAL) Disclaimer of use: We sell products worldwide but regulations differs from country to country. The power output and/or frequency band may not always be legal within your country. Operation of this device may require a license.
PAGE 3
Installation M2x3 Install GV-100TX on aircraft using the included adapter bracket. Installation shown on 500X Quad Flyer. 安裝GV-100TX時可使用內附的轉接板，將GV-100TX安裝至機體上如下圖示意圖。 Hardware Description 安裝轉接板 Attention 請注意硬體介紹 Channel 頻道 Frame adapter bracket Audio out Video out Channel Selection/Set button 頻道切換鍵 Installation view 示意圖 ON / OFF Attention 請注意 Important Note: Never power up the transmitter without the antenna attached or it will cause irreversible damage the transmitter.
PAGE 4
Monitor OSD function description Cabling descriptions 接線圖 Video input 影像輸入 Camera(CCD) 攝影機 Audio input 聲音輸入 Ground wire 地線 12V output to Camera 12V輸出至相機 Digital camera 數位相機 1.Connect Vin, Ain, Gnd, Vcam cables to the camera 將對應的Vin、Ain、Gnd Vcam 訊號接到相機。 2.Connect 3S 11.1V battery then select same channel on both GV-100TX Transmitter and GV-100RX Receiver. 接上3S 11.1V的電池通電並調整TX與RX的頻道為相同。 Li-Po Battery 3S1P 11.1v Digital camera or GoPro have their own power supply.