Instructions for use

* 出廠時已經調整完成，初設值可參考下列說明，各雲台參數會因個體上的差異有所微調，
可自行更改參數使其最佳化(一般調整只需調整輸出功率跟陀螺感度即可)。
* CRANE H3-雲台建議使用電壓為10V-12V，出廠時的參數調整以11.1V電壓調適，如需使用
14.8V需降低參數內功率數值。
* 電源輸入可直接連接動力主電源或單獨10-12V電池。
* 雲台可經搖控設備控制俯仰和橫滾角度，當需控制橫滾角度時，需另加一條訊號線於雲台
控制器上的CH2。
* 姿態校正雲台控制器上方有一按鈕於工作狀態時壓下約五秒，此時控制板上白燈會
改為亮藍燈，雲台本體此時放空(如定格請壓下按鈕使其工作後再次壓下進入校正)將
相機(GOPRO)手調整至水平狀態後再壓入一下按鈕，手離開機架，使雲台本體處於完
全靜止狀態約三秒後藍燈改為白燈，此時校正完成並開始自穩。
使用前請檢查各轉動部分是否順暢
* Gimbal is pre-adjusted at factory, default setting please refer to following, due to the slight
differences of each gimbal, the setting are slightly adjusted.
One can change the setting to get the best result/performance
(usually by adjusting the power output and the gyro gain is sufficient).
* CRANE Hero3 Gimbal suggested voltage is between 10V~12V. At factory the setting
used is 11.1V. If 14.8V is used, one must lower the setting for the power value.
* Power input can be connected to the main power source or independent 10~12V Battery.
* The Gimbal can be controlled by the Radio for Pitch & Roll angles, when control for roll
angle is needed, one must add another signal cable to the Gimbal Controller's CH2.
* Attitude adjustment, on the gimbal controller there is a button, during working condition,
press for about 5 seconds, the white light on the controller will turn blue, at this time the
gimbal is in free condition (if the gimbal is frozen, please press again so it is in working
condition then press again for 5 seconds to enter adjustment/setup mode).
At this time, adjust the GoPro camera to levelled condition then press the button once,
then let the gimbal be in still for about 3 seconds and blue light changes to white light.
At this time the gimbal is adjusted and in self-steady mode.
Before use, please check all rotating parts can move smoothly.
Quick Start Guide
簡易使用說明