Instructions for use

藍白交替閃
串口選擇
連線按鈕
檔按選擇
Blue & White
repeat flash
Blue & White
repeat flash
Com port select
File select
# Upgrade 升級
USB cable plug in PC first, push down and hold the calibration button, then
plug in the other side USB cable into controller and release calibration button,
now the led will become blue and white repeat flash. Open the software and
select correct com port andfirmware then press "Connect" button.
USB線先行插上電腦，按住"校正按鈕"，接著把USB線插上控制器再放開按鈕，
此時LED會呈現藍白燈交替閃，再開啟升級程式選擇正確的串口與檔案然後按下
"connect"按鈕進行升級。