Reflex 75T Balanced Flue User Installation Manual

9
MYFIRE WI-FI KIT
This appliance can be fitted with an optional Wi-Fi kit which can
allow operation from a tablet or smart device:
Gazco part No. 999-055.
Contact your Gazco retailer for more information.
MYFIRE WI-FI TROUBLESHOOTING
The MyFire Wi-Fi box must be wired according to the MyFire set
up diagram and connected to the receiver, which is in turn
connected to the mains power.
Ensure the device is running the most up to date operating system
as older models may not be compatible with the MyFire App.
After 30 seconds the MyFire Box goes into Access Point Mode
(Green LED flashes). See MyFire App instructions supplied and
configure the router.
The following things can affect the Wi-Fi signal on the appliance:
1. Multiple users on the same Wi-Fi channel may interfere with the
data transfer. Press the reset button on the MyFire Wi-Fi box for 1
second to change the current channel.
2. If the MyFire Wi-Fi box is not connected to the receiver or is not
used it will leave Access Point Mode after 24 hours.
3. If there are multiple fireplaces in the household using MyFire
Wi-Fi boxes there must be a minimum of 600mm between them to
avoid interference.
4. If there are any changes to the home network then the MyFire
Wi-Fi set up must be repeated.
Quick Reference Table - for LED.
LED INDICATOR FOR MYFIRE WI-FI BOX
LABEL LED STATUS
Power Blue
On Power On
Off Power Off
WLAN Green
On
Connected to home network
(Wi-Fi Router)
Off
Not connected to home
network (Wi-Fi Router)
Flashing
MyFire Wi-Fi Box in Access
Point Mode
Receiver Blue On Receiver connected
Off
No receiver connected or
connection lost
All LEDs Flashing Internal Conguration
It may be necessary to reset the MyFire Wi-Fi box using a
paperclip or similar,.
The table below shows the length of time required for each reset
and the confirmation signals.
Press Reset
Button
LED Status
Blue Power LED
Function
1 Sec
Continuously
ashes every ½
second
Activates Access Point
Mode for 10mins (connect
MyFire Wi-Fi module to home
network). Simultaneously the
Wi-Fi channel changes.
5 Secs
Two rapid
ashes every 1
second
System Reset.
10 Secs
Flashes
every 100
milliseconds
(Continuous)
Restore factory rmware
(MyFire Wi-Fi module will set
to default after reboot); takes
up to 2 minutes.
20 Secs
Flashes every
50 milliseconds
(Continuous)
Restores factory rmware and
erases all data not locked.
(MyFire Wi-Fi module will set
to default after reboot); takes
up to 2 minutes.