Reflex 75T Conventional Flue User Installation Manual

5
2. Operating the Appliance
The appliance is operated by thermostatic and
programmable remote control.
1
Via the remote it is possible to control the following
features:
2
Child proof
lock
Time
Light
EcoFlex
Mode
Signal
Indicator
Thermostatic
Mode
Dual Burner
Fucntion
Temperature
Program
Mode
Countdown
timer
Battery
Status
NOTE: THE FAN FUNCTION IS NOT AVAILABLE ON
THIS MODEL.
Turning the appliance On
2.1 The handset controls the appliance from pilot ignition
through to shut down.
To turn the fire on press the button until two short
signals and a series of blinking series of lines confirm the
start of the ignition sequence.
The pilot will ignite and the remote is now in Manual
Mode:
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3 MINUTES
BEFORE ATTEMPTING TO RELIGHT.
2.2 There are 4 different modes available for controlling and
operating the appliance:
1. Manual Mode
2. Thermostatic Mode (Automatic)
3. Program Mode (Automatic)
4. EcoFlex Mode (Automatic)
2.3 In MANUAL MODE you can:
— turn on the main burner using the button.
— regulate the flame from high to low and back.
— turn off the burner leaving just the pilot burning.
In THERMOSTATIC MODE (Automatic) you can:
— set the room temperature so the thermostat in the
remote automatically maintains that temperature.
In PROGRAM MODE (Automatic) the fire:
— turns on and off according to the set time periods.
— automatically regulates the room temperature during the
set periods.
In ECOFLEX MODE (Automatic) the fire:
— modulates the flame height between high and low in
response to room temperature. One cycle lasts for 20
minutes.
NOTE: When operating the fire in Thermostatic or
Program mode, the pilot remains lit and the fire then
automatically switches on to bring the room to the set
temperature whether or not you are in the room.
NEVER LEAVE ANY COMBUSTIBLE MATERIALS
WITHIN 1 METRE OF THE FRONT OF THE
APPLIANCE.
Turning the appliance Off (Standy By)
2.4 Press and hold the button to turn the appliance off.
NOTE: There is a 5 second delay before the next ignition is
possible.
Manual Mode
2.5 To turn the fire on press the button until two short
signals and a series of blinking lines on the handset
confirm the start of the ignition sequence and there will be
a clicking sound as the valve opens on the appliance.
Standy By (Pilot Flame) Mode:
Press and hold the button to set the appliance to pilot
flame only.
FOR SAFETY, YOU MUST WAIT 30 SECONDS BEFORE
LIGHTING THE FIRE AGAIN.
User Instructions