Reflex 75T Conventional Flue User Installation Manual
8
User Instructions
Setting the time
Press the and buttons simultaneously. Day
flashes.
Press the or button to select a number that
corresponds with a day of the week (eg 1 = Monday, 2 =
Tuesday, 3 = Wednesday, 4 = Thursday, 5 = Friday, 6 =
Saturday, 7 = Sunday).
Press the and buttons simultaneously. Hour
flashes.
To select hour press the or button.
Press the and buttons simultaneously. Minutes
flash.
To select minutes press the or button.
To confirm press the and buttons
simultaneously or wait.
Setting Fahrenheit or Celsius
To change between °C and °F press and
buttons simultaneously.
NOTE: Choosing °F results in a 12 hour clock.
Choosing °C results in a 24 hour clock.
Troubleshooting
IMPORTANT: In the unlikely event that the handset
fails to communicate correctly with the appliance
it may be necessary to turn off the gas supply at
the isolation valve until any problems can be
resolved.
The gas meter and isolation valve can be located
outside in a meter box, under the stairs, beneath
the kitchen sink or in the garage. Whilst this list is
not exhaustive, it is important to be able to
identify the location of the valve in case of any
gas emergency.
To turn off the gas supply, simply turn the handle
so the lever is at 90 degrees to the upright gas
pipe.
If you smell gas, open doors and windows and
never operate any electrical switches.
Immediately call the Gas Emergency Services on
0800 111 999.
MyFire Wi-Fi kit
2.8 This appliance can be fitted with an optional Wi-Fi kit which
can allow operation from a tablet or smart device, Gazco
part No. 999-055.
Contact your Gazco retailer for more information.
MyFire Wi-Fi Troubleshooting
2.9 The MyFire Wi-Fi box must be wired according to the
MyFire set up diagram and connected to the receiver,
which is in turn connected to the mains power.
Ensure the device is running the most up to date operating
system as older models may not be compatible with the
MyFire App.
After 30 seconds the MyFire Box goes into Access Point
Mode (Green LED flashes). See MyFire App instructions
supplied and configure the router.
2.10 The following things can affect the Wi-Fi signal on the
appliance:
1. Multiple users on the same Wi-Fi channel may interfere
with the data transfer. Press the reset button on the MyFire
Wi-Fi box for 1 second to change the current channel.
2. If the MyFire Wi-Fi box is not connected to the receiver
or is not used it will leave Access Point Mode after 24
hours.
3. If there are multiple fireplaces in the household using
MyFire Wi-Fi boxes there must be a minimum of 600mm
between them to avoid interference.
4. If there are any changes to the home network then the
MyFire Wi-Fi set up must be repeated.
Quick Reference Table - for LED.
LED Indicator for MyFire Wi-Fi box
Label LED Status
Power Blue
On Power On
Off Power Off
WLAN Green
On
Connected to home network
(Wi-Fi Router)
Off
Not connected to home
network (Wi-Fi Router)
Flashing
MyFire Wi-Fi Box in Access
Point Mode
Receiver Blue On Receiver connected
Off
No receiver connected or
connection lost
All LEDs Flashing Internal Conguration
2.11 It may be necessary to reset the MyFire Wi-Fi box using a
paperclip or similar, see Diagram 3.
The table below shows the length of time required for each
reset and the confirmation signals.
3