Logic HE Range Conventional Flue Log Effect Installation User Instructions

20
Installation Instructions
4. Installation of the Appliance
4.1 Ensure that the fireplace opening is in compliance with
Section 2 Site Requirements.
4.2 There are 2 methods of installation:
4a) Cable Retention method
4b) Screw Fixing Method
4a) Cable Retention Method
For this method of installation it will be necessary to remove
the main burner and control assembly.
4a.1 Remove the 2 screws at the front of the burner tray, see
Diagram 2.
2
4a.2 Remove the decorative lip from the front of the fire, see
Diagram 3.
3
Slide Control
model shown
4a.3 Lift the left hand side of the burner tray to disengage from
the injector, before lifting the right hand side, see Diagram 4.
4
Slide Control
model shown
4a.4 Slide the burner tray fully to the left and remove through the
front of the firebox, see Diagram 4.
4a.5 Remove the 2 wing nuts, see Diagrams 5 & 6.
5
Screw
Screw
Wing Nut
Wing Nut
Slide Control
6
Screw
Screw
Wing Nut
Remote Control
4a.6 Remove the 2 screws, see Diagrams 5 & 6.
Slide Control only
4a.7 Remove the M4 lock nut and spacer securing the slider arm
to the appliance and loosen the 2 nuts, see Diagram 7.
Ensure that the spacer is retained and replaced when
the control assembly is reinstalled.
7
M4 Lock Nut and spacer
Nuts