Logic HE Range Conventional Flue Log Effect Installation User Instructions

34
Servicing Instructions - Replacing Parts
1. Servicing
As part of the annual service, the space behind the firebox
must be inspected for any debris, which may have fallen
down the chimney.
1.1 To service the appliance first remove the decorative front.
There are 2 screws securing the front to the appliance.
Refer to separate instructions.
2. Removing the Glass Frame
Ensure the appliance is cold before proceeding.
2.1 Turn the gas supply off at the isolation device. Then
disconnect the supply pipe.
2.2 Remove the glass frame by removing the 4 screws in the
retaining bracket, see Diagram 1.
Detail A
A
1
2.3 Tilt the top of the glass frame forward and disengage
the lower location tabs from the slots in the firebox, see
Diagram 1, Detail A. Place carefully to one side.
2.4 Remove the logs and Embaglow and place on a dry, clean
surface.
2.5 The glass frame must be refitted to the appliance following
cleaning or servicing.
Ensure that the rope seal on the box is intact, then locate
the glass frame location tabs into the slots on the firebox,
see Diagram 1, Detail A.
2.6 Secure the glass frame using 4 screws in the retaining
bracket, see Diagram 1.
Replace ALL of the securing screws ensuring that a screw
is present in all fixing slots.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS
FRAME IS REMOVED OR BROKEN.
Refer to the separate decorative front instructions to replace
the front on the appliance.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
FRAME RETAINING SCREWS ARE LOOSE OR
MISSING.
3. Appliance Battery
3a. Remote Control
It is not necessary to remove the appliance battery to
service the appliance, however the Power Switch on the
Control Box must be switched to the OFF position.
3a.1 The Power Switch is located on the Control Box at the
bottom of the appliance behind the ash cover.
3a.2 Slide the white Power Switch on the Control Box to the
OFF position before servicing the appliance.
2
Power Switch
3b. Slide Control
3b.1 Remove the battery before carrying out work on this
appliance.
3b.2 The battery box is located at the bottom left of the
appliance, see Diagram 3.
3
9V Battery
Ignition
Unit
4. Main Burner
4.1 Remove the 2 screws at the front of the burner tray, see
Diagram 4.
4