Logic HE Range Conventional Flue Log Effect Installation User Instructions

6
Handset Features
4
Battery status
Light Sensor
(for display light)
Day of the week
Appliance Status
Time (12 hour or
24 hour display)
Program Mode
Room
Temperature
Mode:
Man (Manual)
Zzz (Timer)
Thermostat or
Timed
In Range of appliance
(missing if not in or
appliance turned off).
Handset unlocked
(when illuminated)
Change Handset
Settings
Change Mode
Settings
Decrease Button
Increase Button
Power Button
The Icon at the bottom of the screen displays the battery
condition of both the batteries in the handset and in the
Control Box alternatively.
RC = Remote Control Handset and FC = Fire Control
(Control Box).
If the handset has been replaced or the fire has
been serviced, see Installation Section 11b to set
up the handset.
Manual Operation (Remote Control)
To activate the Remote Control it will be necessary
to cradle the handset to unlock, see Diagram 3.
The green light will illuminate to show the handset
is ready to use.
IMPORTANT: Continue to cradle the handset
throughout an operation to keep it unlocked.
If the green light goes off during an operation it will
be necessary to reposition the handset so the light
comes back on and restart the operation.
Turning the appliance on
2b.1 Press the Power Button until Pilot flashes on the display.
2b.2 Release the Power Button and the Flame symbol will
appear on the display.
If the button is held the command will be cancelled for
safety reasons.
2b.3 Holding the handset to unlock, use + and - buttons to adjust
the flame height between Minimum and Maximum.
User Instructions
Turning the appliance off
2b.4 Holding the handset to unlock, press the power button to
turn the appliance off.
IMPORTANT: YELLOW FLAMES TYPICALLY
APPEAR WHEN THE APPLIANCE HAS REACHED
NORMAL OPERATING TEMPERATURE. THIS CAN
TAKE UP TO 30 MINUTES.
WARNING: IF THE APPLIANCE FAILS TO LIGHT OR
BECOMES EXTINGUISHED IN USE, WAIT 3
MINUTES BEFORE ATTEMPTING TO RELIGHT.
THE APPLIANCE MAY TAKE SEVERAL AUTOMATIC
ATTEMPTS TO RESTART.
DO NOT INTERRUPT THE VALVE DURING THIS
PROCESS.
Setting Timer Mode (in Manual operation)
Timer Mode will turn the appliance off after a set period of time has
elapsed.
Timer Mode can be set before or during manual operation of the
fire.
Note: If Timer mode is activated and the fire is
manually turned off, the timer will be cancelled.
Changes to the Timer will reset to the default time
on next use.
If the fire is off when the Timer mode is set then the
timer will automatically start when the fire is turned
on.
2b.5 Hold the handset to unlock and press and release the
MODE button. The word MAN and the Zzz symbols flash at
the top of the display.
2b.6 Press and release the SET button.
This will activate the Timer mode.
The default time period is 1 hour, unless altered in
2b.39.
2b.7 Pressing the SET button again will show the remaining time.
This can be altered by pressing the + or - buttons.
The timer can be set between 1 minute and 24 hours.
2b.8 After adjusting the time press SET again to confirm the time
setting desired.
Once the countdown has reached zero the fire will turn off.
Thermostatic Mode
The handset contains a thermostatic sensor to control the
operation of the appliance according to the temperature of the
room.
There are 3 temperature options that can be set:
Day Mode - indicated by a Sun symbol on the display
(default temperature 24ºC)
Night Mode - indicated by a Moon symbol on the display
(default temperature 18ºC)
Frost Protection - indicated by a Snowflake symbol on the
display (default temperature 5ºC)