Reflex 105 Balanced Flue Installation Instructions

INSTALLATION INSTRUCTIONS

FLUE OPTIONS

8" TOP FLUE UP AND OUT KIT

(999-333/999-333AN)

NOTE: This product is designed for and requires an

8" ue system. It is essential when ordering additional

parts to consult table 1 for the relevant part numbers.

Start of bend to centre line of horizontal ue 198mm. Centre line of

vertical ue to end of bend 248mm.

Vertical from the top of the appliance then horizontally out, see

Diagram. The basic kit comprises:

1 x Horizontal Flue Terminal

1 x 1000mm Length

1 x 90 Degree Elbow

1 x Wall Plate

4 x Fixing Screw

This kit provides the minimum materials. Extra lengths can be

added to the vertical and horizontal sections; see table 1 - 8".

Refer to Installation Instructions, Technical Specication on page 7

to identify when to use a restrictor.

Decide on the terminal position.

Measure the height from the finished hearth level/base of the

appliance to the centre of the required hole.

A masonry installation requires the addition of a suitable lintel to

support the opening. Refer to Installation Instructions, Technical

Information for details of the flue length.

NOTE - Carefully consider:

a) Terminal positions

b) Flue supports

c) Weatherproofing

d) Fire precautions

For all the above options, you must conform to local and national

codes of practice.

Use only Gazco supplied flue on this appliance.

A guard (supplied) must be fitted to any terminal less than 2 metres

above any access such as level ground, a balcony or above a flat

roof.

This Gazco balanced ue system is designed to run

internally with only the terminal projecting from the

building.