Reflex 105 Balanced Flue Installation Instructions

21
INSTALLATION INSTRUCTIONS
ASSEMBLING THE FUEL BED
1
2
Tighten Rear Screws
Replace Front Screws
3
NOTE: Ensure the 2 brackets at the rear are pushed
as far back as possible before tightening.
Position the left hand Log Burner so that the right hand side is
angled up towards the centre of the rebox and the screw hole is
positioned at the front.
Screws
4
Position the centre left and far right Log Burners, so that the screw
holes are positioned at the front.
Secure the burners with the 4 screws provided.
Only use M4x6 Screws to secure the burners.
NOTE: Some burners are pre-tted with Aeration plates. These
are non-serviceable and MUST NOT be altered.
ARRANGEMENT OF FUEL BED
COMPONENTS
ADVICE ON HANDLING AND
DISPOSAL OF FIRE CERAMICS
The fuel effect and side panels in this appliance
are made from Refractory Ceramic Fibre (RCF),
a material which is commonly used for this
application.
Protective clothing is not required when handling
these articles, but we recommend you follow
normal hygiene rules of not smoking, eating or
drinking in the work area and always wash your
hands before eating or drinking.
To ensure that the release of RCF bres are kept
to a minimum, during installation and servicing a
HEPA ltered vacuum is recommended to remove
any dust accumulated in and around the appliance
before and after working on it. When servicing
the appliance it is recommended that the replaced
items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF
waste.
RCF waste is classed as stable, non-reactive
hazardous waste and may be disposed of at a
licensed landll site.
Excessive exposure to these materials may cause
temporary irritation to eyes, skin and respiratory
tract; wash hands thoroughly after handling the
material.
TAKE CARE NOT TO SPILL THE FUEL EFFECT INTO THE
PILOT AREA.
ONLY GENUINE GAZCO PARTS CAN BE USED IN THIS
APPLIANCE.
Use the entire bag of supplied Amber Effect.
The Shale Effect is supplied as large pieces which will need to be
broken into 2-3 smaller shards before placing onto the fuel bed. It is
not necessary to use all the supplied Shale Effect.