Reflex 105 Balanced Flue User Installation Manual

41
Servicing Instructions - Replacing Parts
THE LED'S ARE FRAGILE. HANDLE WITH CARE.
ONLY HOLD THE LED BOARDS BY THE EDGES TO
AVOID CONTACT WITH THE TOP OF THE LED'S.
AVOID CATCHING ANY DELICATE WIRES WHEN
REPLACING THE SCREWS.
5.1 Remove the Log Burners, Fuel effect, and Mesh tray, see
Section 4.
5.2 Remove the screw from the module bracket and carefully lift
to remove, see Diagram 16.
16
Screw
5.3 Disconnect the LED Mains Lead Plug from the Module, see
Diagram 17.
17
LED wires
The LED circuit consists of three components, which can
be individually changed, these are:
5a) Front LED Boards.
5b) Rear LED Bar.
5c) Driver.
5a. Front LED Boards
LED boards 1 - 4 are accessible through the Main Control
Assembly.
5a.1 Remove the corresponding screws securing the glass
covers and remove, see Diagram 18.
18
5a.2 To replace the Front LED boards remove the securing
screw and disconnect the wires on each side of the board.
The board can now be removed, see Diagram 19.
19
Screw
Clip
Clip
5a.3 Repeat for each front LED board.
NOTE: Each board has the wiring direction marked
as IN or OUT on each end to ensure the replacement
boards are wired correctly.
5a.4 Replace the module bracket and glass covers in reverse
order.
5b. Rear LED Bar
Remove the Main Control Assembly to access the Rear
LED Bar (LED board 5), see Section 4.
5b.1 Remove the 2 screws securing the LED cradle to the
underside of the Control Assembly, see Diagram 20.
20
Screw
Screw
*Other internal components removed for clarity