MyFire Wifi Retro Fitting Kit

ManualsBrandsGazco ManualsGas FiresEdge

PR2469 MyFire WiFi Retro Fitting Kit Issue 1 (October 2017)

MyFire WiFi Fitting Kit

For use with the Reflex 75T CF

Serial Number <10500

Instructions for Installation

For use in GB & IE (Great Britain & Republic of Ireland).

IMPORTANT

These products are only for use with the Reflex 75T Conventional Flue products listed and must be installed and

used in accordance with these instructions.

Summary of content (4 pages)

PAGE 1
MyFire WiFi Fitting Kit For use with the Reflex 75T CF Serial Number <10500 Instructions for Installation For use in GB & IE (Great Britain & Republic of Ireland). IMPORTANT These products are only for use with the Reflex 75T Conventional Flue products listed and must be installed and used in accordance with these instructions.
PAGE 2
Installation Instructions General This manual has been designed to show the installation methods available to fit a MyFire WiFi module to the Reflex 75T. Please carefully read in conjunction with the Installation Instructions for the Reflex 75T (PR2272) making sure the appropriate method is understood before attempting to install the product. 1.6 2 Remove the 2 screws from the front of the Mesh Tray, see Diagram 2.
PAGE 3
Installation Instructions 2.3 Secure the velcro pads to the underside of the WiFi module and position in the allocated position, see Diagrams 4 & 5. 2.5 4 7 Feed the mains adapter lead through the rear left-hand panel (alongside the gas supply) and towards the front edge of the firebox, see Diagram 7. Insert the lead into the allocated slot on the receiver module. Ensure the wire does not obstruct any internal components.
PAGE 4
Installation Instructions 2.8 The WiFi module is now accessible, see Diagram 12. Replace the Main Burners and Fuel Effect, see PR2272 (Conventional flue). 12 3. Accessing the WiFi Module Once installed, the WiFi module can be accessed by following the below instruction. 3.1 If Fitted, remove the Glass Frame, see PR2272, Servicing Instructions, Section 2. 3.2 Remove the two screws securing the service hatch and slide across, see Diagram 11.