Reflex 75T Multi Sided Balanced Flue User Manual
9
CLEANING THE APPLIANCE
From time to time it may be necessary to remove build up of debris
and soot from the logs.
Make sure the appliance and surrounds are cool before cleaning.
Remove the side trims and lower trim from the appliance.
Loosen the 7 screws securing the pivot brackets (do not remove).
Using the tool provided turn the 7 Pivot Brackets (4 Top, 3 Bottom)
90° anti-clockwise to the open position.
Top Pivot Brackets
Bottom Pivot Brackets
With the Cam Lock Brackets open, slide the top and bottom support
brackets away from the Front Glass.
Top Support Bracket
Bottom Support Bracket
Gap
Gap
The Front Glass can now be removed.
Carefully move the front glass into the gap, then lift and manoeuvre
the bottom outwards to remove.
The side glass does not need to be removed to clean the
appliance.
It is recommended to leave the Side Glass in situ unless
absolutely necessary.
Should the logs require cleaning, lightly brush with a soft brush. Any
large pieces of debris may be removed by hand.
DO NOT USE A VACUUM CLEANER.
Use a damp cloth to clean the outer casing of the appliance.
To clean the glass surface use a non abrasive glass cleaner and
soft cloth.
The glass panel must be retted to the appliance following cleaning
or servicing.
To replace the glass panel, replace in reverse order.
UNDER NO CIRCUMSTANCES SHOULD THE
APPLIANCE BE USED IF ANY OF THE GLASS
PANELS ARE LOOSE, DAMAGED, OR MISSING.
Replace the lower and side trim.
ENSURE THAT ALL GLASS PANELS ARE FLUSH AND THAT
THERE ARE NO GAPS BETWEEN PANELS.
NEVER OPERATE THE APPLIANCE WHEN THE GLASS PANEL
IS REMOVED OR BROKEN.
USER INSTRUCTIONS