Logic HE Balanced Flue Combined Controls Installation User Instructions

ManualsBrandsGazco ManualsGas FiresHE Conventional Flue

1. Servicing Requirements

IMPORTANT – The glass panel on this appliance should be

checked for any signs of damage on the front face of the

glass panel (scratches, scores, cracks or other surface

defects). If damage is observed, the glass panel must be

replaced and the appliance must not be used until a

replacement is installed. Under no circumstances should the

appliance be used if any damage is observed. Please isolate

the appliance until a replacement glass panel has been

obtained and installed. Replacement glass panels can be

purchased from Gazco via the retailer from which the

appliance was purchased or any other Gazco distributor.

This appliance must be serviced at least once a year by a

competent person.

All tests must be carried out in accordance with the current

GasSafe recommendations.

1.1 Before Testing:

— Conduct a gas soundness test for the property ensuring

there are no leaks before servicing.

— Check the operation of the appliance before testing.

1.2 Special checks:

— Clean the burner using a vacuum cleaner with a soft

brush attachment. Ensure all debris is removed from the

burner ports.

— Check the flue terminal position complies with the

requirements, and that the terminal is not obstructed.

— Clean away any debris under the burner.

— Check the condition of ceramics, pilot and burner cover

gasket.

— Ensure that the glass frame is secured correctly and that

all retaining screws are in place.

1.4 Correct any faults found during the initial tests

1.5 Re-commission the appliance in accordance with

Commissioning Procedures of these instructions.

1.6 Advise the customer of any remedial action taken.

Servicing Instructions

Servicing/Fault Finding Charts

PILOT WILL NOT LIGHT

Ensure there is no debris around the pilot assembly,

(e.g. soot, etc.) which could short the spark, clean the area.

There is a blockage in the system, check the inlet test point,

the mag seating and valve

Operate the valve.

Is there a spark?

Does the pilot light?

Is the control being

operated correctly?

Will the pilot light

with a match?

Is the gas turned on to

the appliance?

Is the gas pressure

correct?

Has the system got

any air in it?

SYSTEM OK

Consult users book

and retry

Check isolation tap

and gas meter, retry.

Correct and retry.

Purge the gas pipes

and retry

GO TO THE NEXT

CHART IGNITION

FUNCTIONAL CHECK 2

Check alignment of pilot

burner head. Change the

ignition lead.

See Replacing Parts,

Section 6.

Yes

IGNITION FUNCTIONAL CHECK 1