Logic HE Conventional Flue Combined Controls Installation User Instructions

22
5. Fitting the Decorative Inner Panel
- White Stone Effect
5.1 By rotating the panel, insert into firebox, see Diagram 15.
15
5.2 Check that the panel is sitting behind the rear ledge of the
burner, see Diagram 16.
16
5.3 Secure the panel using the 2 upper brackets and the
pozidriv screws, Diagram 17.
Use only the rearmost hole in the retaining bracket on each
side.
NOTE: IT IS IMPORTANT TO ENSURE THAT THE PANEL
LOCATES TIGHTLY AGAINST THE BURNER TRAY.
17
Installation Instructions
6. Arrangement of the Fuel Bed
Advice on handling and disposal
of fire ceramics
The fuel effect and side panels of this
appliance are made from Refractory Ceramic
Fibre (RCF), a material which is commonly
used for this application.
Protective clothing is not required when
handling these articles, but we recommend you
follow normal hygiene rules of not smoking,
eating or drinking in the work area and always
wash your hands before eating or drinking.
To ensure that the release of RCF fibres
are kept to a minimum, during installation
and servicing a HEPA filtered vacuum
is recommended to remove any dust
accumulated in and around the appliance
before and after working on it. When servicing
the appliance it is recommended that the
replaced items are not broken up, but are
sealed within heavy duty polythene bags and
labelled as RCF waste.
RCF waste is classed as stable, non-reactive
hazardous waste and may be disposed of at a
licensed landfill site.
Excessive exposure to these materials may
cause temporary irritation to eyes, skin and
respiratory tract; wash hands thoroughly after
handling the material.
6A. White Stone Layout
ONLY USE THE CORRECT TYPE AND QUANTITY OF
WHITE STONES. ALWAYS FOLLOW THE FUEL BED
LAYOUT AS STATED IN THESE INSTRUCTIONS. NEVER
CHANGE THE LAYOUT FROM THAT SHOWN HERE.
6.1 Arrange the white stones in the areas highlighted in
Diagram 18. They should be evenly distributed.
18