Logic HE Conventional Flue Combined Controls Installation User Instructions

23
Installation Instructions
6.2 Lean the white stones against the burner ledges to disguise
the ledges, see Diagram 19.
19
6.3 Check that the port area, see Diagram 20, Arrow A is clear
of white stones. This can be easily done by gently running a
screwdriver or similar object along this area.
NOTE: IT IS IMPORTANT THE WHITE STONES DO NOT
COVER THE PORT AREA IN BETWEEN THE BURNER
LEDGES.
A
20
6.4 Ensure that no stones overhang or fill the pilot area, see
Diagram 21, Arrow B.
NOTE: STONES SHOULD NOT BE PLACED DIRECTLY
IN FRONT OF THE PILOT CROSS LIGHTING FLAME.
B
21
6B. Coal Effect Layout
NOTE: CERAMIC PARTS ARE FRAGILE. HANDLE WITH
CARE.
ONLY USE THE CORRECT TYPE AND QUANTITY OF
CERAMIC COMPONENTS. ALWAYS FOLLOW THE FUEL
BED LAYOUT AS STATED IN THESE INSTRUCTIONS.
NEVER CHANGE THE LAYOUT FROM THAT SHOWN
HERE.
6.5 Ensure the burner cover gasket is positioned on the burner
skin ensuring the holes align with the ports.
Take care as the front left-hand hole is offset compared to
the others, see Diagram 22, arrow A.
A
22
Manual Model
shown
6.6 Place the rear panel against the rear of the box resting on
the shelf.
6.7 Slide one of the side panels into the box ensuring it touches
the rear panel.
6.8 Gently ease the front edge of the side panel behind the
flange so it lies flat against the wall of the box.
6.9 Repeat with the second side panel, see Diagram 23.
23
6.10 Locate the top panel on top of the sides and rear by lifting it
up and forward inside the box.