Logic HE Conventional Flue Combined Controls Installation User Instructions

26
Installation Instructions
YELLOW FLAMES APPEAR WHEN THE APPLIANCE
HAS REACHED SUFFICIENT HEAT – (10 TO 20
MINUTES).
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE TRYING TO RELIGHT.
Switching OFF the Appliance
8.7 To switch the appliance off turn the control knob clockwise
until it is returned to the off position, see Diagram 37.
37
Rotate clockwise
The knob should be upright.
Remote Control
The control valve is at the foot on the right-hand side of the
appliance. It has two controls, see Diagram 38:
1. The right-hand knob controls the pilot ignition.
2. The left-hand knob controls the main burner.
Lighting the Pilot
8.8 To start the left-hand and right-hand control knobs must
both point to off ( ):
38
8.9 Press in the right-hand control knob and rotate anti-
clockwise until a click is heard. Continue to press in. The
knob points to the pilot ( ).
The pilot is lit.
8.10 Keep the knob depressed for 10 seconds before releasing.
The pilot remains lit.
Repeat the above steps if the pilot does not stay lit.
NOTE: If the pilot goes out, the Interlock system
prevents you lighting again for a short period.
8.11 If, after repeating the above steps the pilot does not light,
contact your Retailer or Installer.
8.12 Turn the right-hand control to point to main burner
( ). The appliance can now be controlled by the remote
handset.
8.13 The Standard remote controls the appliance when:
— the pilot is lit.
— the right-hand control points to main burner ready to
operate position.
It regulates the temperature from low to high and back.
It can also turn the main burner off leaving just the pilot
burning and ready to operate.
A
B
C
39
To light the main burner:
8.14 Press buttons A & B simultaneously.
The remote’s LED light flashes to show communication
between the appliance's controls and the remote.
Adjusting the Flame height:
8.15 Press and hold buttons A & B simultaneously to increase the
flame height. A clicking sound indicates that the appliance is
at maximum.
8.16 Press and hold button C to decrease the flame height.
Continue to press C to turn off the main burner.
To make small adjustments to flame height:
8.17 Press and hold down button B and press button A once to
make a slight increase. This increases the temperature by
stages.
Repeat to further adjust.
8.18 Press button C once to slightly reduce the flame height.
YELLOW FLAMES APPEAR WHEN THE APPLIANCE
HAS REACHED SUFFICIENT HEAT – (10 TO 20
MINUTES).
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE TRYING TO RELIGHT.
Switching OFF the Appliance
THE REMOTE CONTROL CAN TURN THE MAIN BURNER
OFF AND LEAVE THE PILOT BURNING AND READY TO
OPERATE .
8.19 To switch off the appliance completely (no pilot burning)
return both control knobs to the off position ( ).