41215-12 SAND 41215-32 SLATE 12 X 15 SOLARIUM ASSEMBLY INSTRUCTIONS DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS Three adults required for assembly Base Dimensions 12’ ½”x15’6”, Largest Dimensions 13’6”x16’11” Overall Height 110’’ (see pg.21) APPROX. 1 ZZZ-183.41215.1116-20.GP.EN.
DO NOT DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED PLEASE VERIFY THE CONTENT OF EACH BOX AGAINST THE LIST OF PARTS 12ft x 15ft / 3.66m x 4.57m Solarium Instruction Manual IMPORTANT: RETAIN FOR FUTURE REFERENCE, READ CAREFULLY Consult with your local governing authority / local municipal codes regarding installation of temporary structures before purchase or assembly. Some jurisdictions may require permits for, or otherwise regulate, installation and use.
MAINTENANCE NOTES 1. In case of a defective or damaged part, or for any other questions concerning the product, please contact the manufacturer directly. 2. Please have the parts list and part numbers on hand when ordering or requesting replacement parts. 3. The product should not be installed adjacent to trees or a sloped roof. Snow and ice may slide onto the roof and cause it to collapse. 4.
Before You Assemble the Solarium PLEASE DON'T DESTROY THE BOXES UNTIL COMPLETELY ASSEMBLED Tools needed: Step Ladder 6’-8’ #2 Phillips, #2 Robertson Screwdriver (not supplied) Rubber Mallet Various Files 12” piece of wood Based on the location, decide where you would like to position the two (2) doors panels which can slide open to the left or the right, your choice. Slide left to open Slide right to open 4 ZZZ-183.41215.1116-20.GP.EN.
12x15 Solarium Assembly Instructions Step 1: Before starting to assemble, please decide where you would like to position the door panels. 1. Stand up two regular frames (A), using two connecting pieces (E) and affix the panels (A) together. 2. Stand up a frame meant to be next to the door (B) and a door frame (D), placing the door frame either on the left or right, then use two connecting pieces (E) to affix the panel and door frame. 3.
Step 2: 1. Slide top door rail (F) into wheels of sliding door. 2. Slide lower door rail (G) into the plastic guide of the sliding door (C). 3. Use bold (Bb) to affix the plastic stoppers (H) one on each end of top door rail (F). 4. Use screw (Oo) to affix upper door rail end caps (Nn) one on each end of top door rail (F). Step 3: Please note the sliding door should be installed from the inside of the solarium. 1.
Step 4: 1. Attach roof rafters (L) to the central hub (N) using bolt (Bb). 2. Use screw (Z) to affix the rafters (L) onto the top of panels going through the metal piece attached to the rafter (L). Note: Rafters must be affixed where panels connect to each other. Step 5: Use the same method to assemble roof rafters (K) for the angled panels. The rafters (K) should be affixed to the mounting bracket using the hole that will be furthest away from the corner of the unit.
Step 6: Use nut (Hh) and washer (Gg) to affix the top cap (M) to the central hub (N). Step 7: First remove the protective layer from the PC roof panels, then insert them (Y, Aa, Ll, Qq) into the roof rafters according to the below drawing instructions. Note: the side that had the protective layer should be face down. K 8 ZZZ-183.41215.1116-20.GP.EN.
Step 8: After inserting the upper PC panels, insert the aluminum middle roof joints (O, P, Q, Pp) into the roof rafters. The below drawing view is from inside the solarium looking up. Note: The drain holes on the aluminum middle roof joints (O, P, Q, Pp) should be at the bottom.
Step 10: Once the PC roof is complete, use aluminum edging ( S, U, W, Ss) to surround the edges of PC roof, and using bolt (Bb) and roof joint (R), tighten securely. Step 11: Once the installation of the edging complete, start affixing the roof cross bars (T, V, X, Tt) using bolt (Ff). Affix the top cross bars (Uu) onto the roof rafter (L) using bolt (Ff). 10 ZZZ-183.41215.1116-20.GP.EN.
Step 12: Inside each of the panels (A, B), push two plastic plugs (Ii) into the ground, and then screw down the panels using two screws (Ee) for each panels. Special notes: 1. To remove windows (08-219), pull 1 pin out of the lock position and push the frame to the end of the track, then ease the window out of the tracks one side at a time. 2. To remove screening panel, first remove windows, then unscrew the 2 screws at the top corners of the screen frame. 3. Note that this unit is not waterproof.
*Suggestions The below mentioned are only suggestions in order to permit drainage, these will vary depending on your flooring – material, flatness and slope. 12 ZZZ-183.41215.1116-20.GP.EN.
08-129-12 PACKED IN BOX 5 FRAME NEXT 3 5 2 1 (with extra holes) 08-132-12 SLIDING SLIDING DOOR DOOR FRAME 3 C 1 08-133-12 12 08-137-12 4 2 G D RAIL PLASTIC STOPPER 08-139-12 08-140-12 135° ANGLED 135° ANGLED OUTSIDE INSIDE 4 8 CONNECTOR I J Length 200.6 Length 200.6 cm cm 08-141-12 2 1 3 1 4 2 5 4 4 8 4 6 5 1 5 4 08-142-12 ROOF ROOF 4 8 RAFTER L Length 239.
08-147-12 MIDDLE ROOF JOINT QTY DESCRIPTION IN BOX DRAWING PACKED QTY IN BOX PACKED DESCRIPTION DRAWING 08-148-12 5 4 Q ROOF RAFTER CAP 5 14 5 4 5 4 5 4 5 28 5 54 5 2 5 24 R 08-150-12 08-149-12 EDGING S ROOF CROSS 5 4 T Length 120.6 cm Length 94.4 cm 08-152-12 08-151-12 EDGING U BAR ROOF CROSS 5 4 BAR V Length 120.6 cm Length 94.4 cm 08-154-12 08-153-12 EDGING W ROOF CROSS 5 4 BAR X Length 94.4 Length 120.
IN BOX 08-168-12 DESCRIPTION PACKED IN BOX DRAWING 08-187-12 5 BOLT DRAWING QTY PACKED QTY DESCRIPTION 18 Ff WASHER 5 39 5 24 1 4 1 4 5 4 1 2 5 2 5 2 5 12 Gg 08-193-12 08-189-12 ACORN NUT 5 3 Hh PLASTIC PLUG Ii 08-196 08-195 (46 ¼”x43”) (47”x47 ½”) BOTTOM ROOF 1 4 CORNER PANEL BOTTOM ROOF LEFT PANEL Jj Kk 08-198 08-197 (46 ¼”x43”) (24 ¼”x42 ½”) TOP RIGHT 1 4 ROOF PANEL BOTTOM ROOF RIGHT PANEL Ll Mm 08-134-12 UPPER DOOR RAIL END CAP 08-135-12 5 4
AVAILABLE REPLACEMENT PARTS DESCRIPTION DRAWING DESCRIPTION DRAWING 11-572-12 08-219-12 BOTTOM PVC WINDOW PLASTIC PANEL (in frame) (for wall panels) 10-493 11-823-12 PVC WINDOW BOTTOM (replacement PLASTIC PANEL material only) (for double doors) 85-417-P 15-097-12 ROUND SPLINE DOOR WHEEL FOR PVC ASSEMBLY WINDOW 11-736-12 15-123-12 RECEIVER PIN FOR PVC CHANNEL FOR WINDOW DOUBLE DOOR 13-054 10-458 PC WINDOW REPLACEMENT (for double door) WEATHERSTRIP 12-046-12 15-124-12
08-129-32 PACKED IN BOX 5 FRAME NEXT 3 5 2 1 (with extra holes) 08-132-32 SLIDING SLIDING DOOR DOOR FRAME 3 C 1 D 08-133-32 08-136-32 CONNECTING TOP DOOR 4 PIECE 12 RAIL E F Length 200.6 cm Length 206 cm 08-137-32 4 2 G PLASTIC STOPPER 08-139-32 08-140-32 135° ANGLED 135° ANGLED OUTSIDE INSIDE 4 8 CONNECTOR I J Length 200.6 Length 200.6 cm cm 08-141-32 K 1 3 1 2 1 3 1 4 2 5 4 4 8 4 6 5 1 5 4 ROOF 4 8 RAFTER L Length 239.
08-147-32 MIDDLE ROOF JOINT PACKED DRAWING DESCRIPTION IN BOX QTY IN BOX QTY PACKED DESCRIPTION DRAWING 08-148-32 5 4 Q ROOF RAFTER CAP 5 14 5 4 5 4 5 4 5 28 5 54 5 2 5 24 R 08-150-32 08-149-32 EDGING ROOF CROSS 5 S 4 T Length 120.6 cm Length 94.4 cm 08-152-32 08-151-32 EDGING ROOF CROSS 5 U BAR 4 BAR V Length 120.6 cm Length 94.4 cm 08-154-32 08-153-32 EDGING ROOF CROSS 5 W 4 BAR X Length 94.4 Length 120.
IN BOX 08-168-32 DESCRIPTION PACKED IN BOX DRAWING 08-187-32 5 BOLT DRAWING QTY PACKED QTY DESCRIPTION 18 Ff WASHER 5 39 5 24 1 4 1 4 5 4 1 2 5 2 5 2 5 12 Gg 08-193-32 08-189-32 ACORN NUT 5 3 Hh PLASTIC PLUG Ii 08-195 08-196 (47”x47 ½”) (46 ¼”x43”) BOTTOM ROOF CORNER 1 4 BOTTOM ROOF LEFT PANEL PANEL Jj Kk 08-198 08-197 (46 ¼”x43”) (24 ¼”x42 ½”) TOP RIGHT 1 4 ROOF PANEL BOTTOM ROOF RIGHT PANEL Ll Mm 08-134-32 UPPER DOOR RAIL END 08-135-32 5 4 C
AVAILABLE REPLACEMENT PARTS DESCRIPTION DRAWING DESCRIPTION DRAWING 11-572-32 08-219-32 BOTTOM PVC WINDOW PLASTIC PANEL (in frame) (for wall panels) 10-493 11-823-32 PVC WINDOW BOTTOM (replacement PLASTIC PANEL material only) (for double doors) 85-417-P 15-097-32 ROUND SPLINE DOOR WHEEL FOR PVC ASSEMBLY WINDOW 11-736-32 15-123-32 RECEIVER PIN FOR PVC CHANNEL FOR WINDOW DOUBLE DOOR 13-054 10-458 PC WINDOW REPLACEMENT (for double door) WEATHERSTRIP 12-046-32 15-124-32
Note: The dimensions are approximate. 21 ZZZ-183.41215.1116-20.GP.EN.