Installation & Assembly

ZZZ-205.43226-32.1217-18.GP.EN.HER HER-HR

Step 9:

Slide the indicated

polycarbonate panels into

the spaces between the

rafters, using the top

groove of each rafter.

Ensure the side meant to

face the sun is on the

outside. Use a rubber

hammer to carefully tap

each panel into the

grooves.

Step 10:

Insert the middle roof joints in between the rafters and slide them up under the polycarbonate panels.

Tap lightly to ensure the panel is fully in the slot. Seen from above, most of the joint as well as the

drain holes should be beneath the roof panels.

To adjust the middle joints to line up : once all polycarbonate roof panels are in place, use a small

piece of wood and hammer, then tap down on the middle of the joint bringing it down and holding at

the same time the joint and top polycarbonate.

Do not tap too hard.