KAS
Crease Matic 150 The new Crease Matic 150 is a fully programmable card creaser developed specifically for the short to medium run digital print market. Designed and Manufactured in the UK. It bridges the gap between desk top card creases and suction fed models. Over 2000 sheets per hour can be stream-fed by hand – simply advance the sheet to the input rollers and the Crease Matic takes over. Up to 9 creases per sheet can be programmed for card sizes A5 to SRA3 and 6 -page A4.
Crease Matic 150 Operation: The creasing machine has five (5) programs that are saved on power down. Each program may contain up to nine (9) crease positions. There is no limit to how close together, or how close to the sheet edge, the creases may be. On power up, the creaser will check the position of the knife. If it is out of position, or there is paper present under the photocell, ‘9999’ flashes on the screen. Press the key to cycle the crease head and/or eject the paper.
Crease Matic 150 Operation (continued): In ‘run’ mode the feed motor and/or crease motor may be stopped at any time by pressing any of the four keys. To restart the feed motor, press the key. If the feed motor is stopped and the zero. key is pressed, the sheet counter is reset to If the feed motor is stopped and the ‘setup’ mode. key is pressed, the machine will go back to If the feed motor is stopped and the key is pressed, the feed motor will run. The machine has entered ‘edit’ mode.
Crease Matic 150 mechanical adjustment and maintenance: Knife Driver 1) Knife Depth Adjustment Blocks 2) Screws for Adjustment of RHS Lay RHS Lay 3) Bolts for Adjustment of LHS Lay 3 2 LHS Lay Crease Block LHS Lay Support Bar Turn the Power off. 1) Knife depth adjustment: Using a 13mm spanner loosen the lock nuts on both adjusters. With the crease block set with the narrow tool up, turn the knife driver to bottom dead centre, driving the knife down.
New Job Setup: 1. Ensure Crease Matic is in ‘setup’ mode. Decimal point in last position of screen and LED off. Select job number to program, then press ‘crease’. 2. Push card gently to infeed wheels. The Crease Matic will feed the card to the creasing blade. 3. Press the ‘left’ key until distance from edge is reached (99.00mm). Press creaser button 4. Press forward again until distance from 1st crease is reached (198.00mm). Press creaser button 5.
CROSS Power on Reset memory Sensor to crease = 16 Setup mode Last D.P. on screen Exit to run Setup Last D.P. on screen LEFT CREASE RIGHT Edit sensor to crease distance setting If ‘9999’ displayed at start up.
CROSS LEFT CREASE Power on RIGHT If ‘9999’ displayed at start up. Press to reset knife Setup mode Last D.P. on screen Exit to run Index job Setup job Display job Setup Last D.P. on screen Exit to run Forward Crease and save setting Back (slow) Run mode Green LED Start Stop (if motor running) Reset counter Stop (if motor running) Edit job Stop (if motor running) Exit to setup Stop (if motor running) Edit Second D.P.
Upper perforator wheel Top perforating wheel is pushed against spring as perforator is closed Do not adjust this screw Upper shaft Control wheel Control wheel Lower shaft Lower perforating wheel 1/8”(3.17mm) 1/4” (6.
Spring loaded pin Shaft flat Telescopic end piece Upper perforating wheel Collar Top shaft Control wheels Control wheels Lower perforating wheel Smoother guides Rule Perforator unit Bottom shaft