Instruction Manual Manuel d’utilisation Manual de instrucciones To Register this product go to www.gbc.com Pour enregistrer ce produit allez sur www.gbc.com Para registrar este producto entre en www.gbc.
English 4 Français 10 Español 16
1 2 3a 3b 4 5 6 7 8 TH RE AD IN G CA 9 10 RD
Important Safety instructions YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT TO GBC. IN THIS INSTRUCTION MANUAL AND ON THE PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE MESSAGES CAREFULLY. Important Safeguards THE SAFETY ALERT SYMBOL PRECEDES EACH SAFETY MESSAGE IN THIS INSTRUCTION MANUAL. ON THE PRODUCT YOU WILL FIND IMPORTANT SAFETY MESSAGES. READ THESE MESSAGES AND INSTRUCTIONS CAREFULLY. SAVE THESE INSTRUCTIONS FOR LATER USE. THE FOLLOWING WARNINGS ARE FOUND ON THIS PRODUCT.
Service Perform only the routine maintenance procedures referred to in these instructions. Do not attempt to service or repair the laminator. Unplug the unit and contact an authorized GBC service representative for any required repairs or one or more of the following has occurred: • The power supply cord or attachment plug is damaged. • Liquid has been spilled into the laminator. • The laminator is malfunctioning after being mishandled.
Features Guide A. POWER SWITCH: Located at the back of the machine, applies power to the laminator. The ‘ON’ position is indicated by the ‘ ’ symbol. The ‘OFF’ position marked ‘ ’ symbol (figure 1). I. NIP ROLLERS: (figure 3b) The Nip Rollers are located behind the heat shoes. The nip point is where the heated film is compressed and pulled through the laminator. B. CONTROL PANEL: (figure 2) J. PULL ROLLERS: (figure 4) The Pull Rollers are located at the back of the laminator.
Film Loading and Threading Refer to Figure 6 and follow the procedures to remove the Feed Table and Heat Shield. 1 Remove the heat shield by sliding it to the left or right and lifting it up and away from the laminator. 2 Slide the feed table latch to the left. 3 Lift the feed table upwards and away from the laminator. CAUTION: HEAT SHOES COULD BURN YOU. A If reloading film, cut the remaining top and bottom film webs between the supply rolls and heat shoes.
Operation 1 2 3 Specifications CAUTION: MAKE SURE HEAT SHIELD AND FEED TABLE ARE IN THE PROPER POSITION TO OPERATE THE UNIT. Move the Main Power switch to the ‘ON’ ( ) position (figure 1). With the main power switch in the ‘ON’ ( ) position, the laminator can be turned on or off using the standby switch ( ) located on the control panel. When the standby switch is activated the red power indicator ( ) will illuminate. The laminator is now heating.
Troubleshooting Guide SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION • POWER indicator does not illuminate when Main power switch is in the ‘ON’ ( ) position. Standby switch on control panel is not activated. Push standby switch on control panel. Laminator is not connected to electrical supply. Insert plug into appropriate receptacle. Fuse is blown. Replace fuse. • Laminated items are wrinkled. Tension on top or bottom supply roll is too loose. Film holder lever is not closed.
General Binding Corp. Northbrook, Illinois 60062, USA www.gbc.
