Instruction Manual

14
5. PREPARATION FOR CUTTING
5.1 Use the BC-10 only in the conditions described in the PRECAUTION OF
INSTALLATION section.
5.2 Make sure the Power Switch is off.
Connect the power cord into a wall-mounted outlet.
5.3 If a three-hole outlet is not available, ground the power cord with the adapter.
5.4 To set the paper
1. Jog a stack of sheets.
2. Place the stack on the Paper Feeder Tray face-up.
3. Press down the Left Paper Guide on the Paper Feeder Tray to turn the feeding
status "off."
4. While pressing down the Left Paper Guide, slide the paper down until it stops.
5. Release the Left Paper Guide to turn the feeding status "on."
w Load limit is 50 sheets (Sheet thickness: 0.20mm / 0.008").
5.5 Turn on the Power Switch.
The Display in the center of the Operation Panel will light up.
CAUTION:
Never use the cord to pull the plug from an outlet.
DANGER:
Do not connect or disconnect the power cord with wet hands
in order to avoid electric shock.