Instruction Manual

18
w In the "Adding" mode, the BC-10 stops when it runs out of sheets.
w In the "Preset" mode, the machine stops when the "Preset" numbers of sheets
are finished. And two seconds later, the "Preset" number apears again in the
Display. Press the Start button again to repeat the same job.
w To
stop cutting, press the Stop button. The "Stop" LED turns on and the BC-10
stops after cutting the current sheet. Do not press the Start button until the
machine stops.
6.11 Move the Slitter Unit to adjust the side margin.
1. Loosen the Slitter Unit Adjusting Screws.
2. Using the Slitter Unit Adjusting Gauge (located on the Slitter Unit), slide the
Slitter Unit the necessary amount. The Slitter Unit can be moved about .08
inches or 2 mm from center.
3. Ti
ghten the screws up after an adjustment.
6.12 Emergency stop and safety features
The Upper Cover and the Trash Box are electrically interlocked with the
machine so that the BC-10 stops immediately whenever either one of them is
opened or pulled out.
w For emergency stops, open the Upper Cover or pull out the Trash Box.
w To restart the machine, jclose the Upper Cover or insert the Trash Box
completely, kremove any jammed sheets, and lpress the Start button.
The machine will not restart unless the Upper Cover is closed and the Trash Box
is returned.
Top Margins
CAUTION:
Never disassemble the Cutter Unit or the Slitter Unit.
Serious injury could result.
Cutting Mode Upper Limit Lower Limit
Adjusting
Step
55 x 90 mm single cut
55 x 90 mm double cut
51 x 90 mm double cut
2 x 3.5 inches single cut
2 x 3.5 inches double cut
11 mm
7 mm
11 mm
0.5 in.
0.25 in.
14.0 mm
8.0 mm
14.0 mm
0.610 in.
0.291 in.
8.0 mm
6.0 mm
8.0 mm
0.390 in.
(0.315 in.)
(0.315 in.)
(0.551 in.)
(0.551 in.)(0.433 in.)
(0.276 in.)
(0.433 in.) (0.010 in.)
(0.010 in.)
(0.010 in.)
(0.236 in.)
(0.315 in.)
0.209 in.
0.25 mm
0.25 mm
0.25 mm
0.014 in.
0.014 in.
Standard Top
Marg
in