.0 INTRODUCTION 1.
.0 SPECIFICATIONS DESCRIPTION: Punch/Binder PUNCH CAPACITY:* 1/8 in. (3.2 mm) X 14 in. (355.6 mm) 25 sheets of 20 lb. bond paper *Note: No more than 4 composition covers, or 3 plastic covers should be punched at one time. Punching stacks of these materials may result in damage to the punch mechanism. BIND CAPACITY: 1 in. (25 mm) X 14 in. (355.6 mm) 250 pages of 20 lb. bond paper ELECTRICAL REQUIREMENTS: 120 VAC 230 VAC 60 Hertz 50 Hertz 3 Amps 1.5 Amps 409.56 B.T.U.
.0 INSTALLATION PROCEDURE 3.1 Unpacking Instructions To unpack the machine, carefully remove the staples and open the carton. Remove the packing material from the top and around the machine, and lift the machine straight up out of the carton. Place the machine on a table near a 120 VAC or 220240 VAC grounded outlet, and remove the plastic bag. 3.2 Power Cord Configuration This machine is supplied with a power cord terminating in a conventional three prong electrical plug.
.0 OPERATING INSTRUCTIONS 4.1 Punching 1. Adjust the punch edge guide to the correct paper length. Check the punch alignment by punching a sheet of paper and folding it in half along the punched edge (See Figure 4-1). Match the holes up: if the corners of the paper match with no overlap, the alignment is correct. If not, readjust the guide and repeat the process until the edges are square. 2. Place the paper fully in the punch throat and slide the paper to the left against the punch edge guide.
4.0 OPERATING INSTRUCTIONS 4.2 Document Assembly 1. Check the bind edge guide alignment by inserting a receiving strip in the strip recess area. Lay a sheet of correctly aligned punched paper on the strip, matching up the holes and the strip so that the strip is not showing at the top or the bottom of the paper. Adjust the bind edge guide if necessary by sliding the guide to the edge of the paper. 2.
4.0 OPERATING INSTRUCTIONS 4.3 Binding 1. Begin the binding process by pulling the pressure bar toward you and lowering it on top of the document. The indicator light will illuminate. 2. Pull the handle down in a uniform, smooth motion and leave it down. (Don't apply pressure, the handle will remain down until you lift it.) 3. Approximately 9 seconds after the handle is pulled down, the indicator light will go out, indicating the binding process is complete. 4.