User Manual

in the ControlCam App without entering the ‘Edit’ mode; ‘Unlock password,
‘Unlock delay’, ‘Auto unlock’, and ‘Outdoor call-in’
o Unlock password setting: Tap ‘Unlock password setting’, enter the old
4-digit password, and then enter the new 4-digit password. The
password must be 4 numbers and can not begin with ‘00’. *Note:
Changing the password here changes the unlock password for all
ControlCam Apps accessing the IP Doorbell, as well as the Web Server
interface.
o Unlock Delay: To change the time duration of the Unlock relay, tap
‘Unlock Delay’ and move the slide adjustment to the desired time (0 –
99 seconds).*Note: on iOS devices the unlock delay time adjustment is
accessed by tapping the ‘. __’ icon in the upper right corner of the main
‘Devices’ page.
o Auto Unlock: This feature allows the user to trigger the Unlock relay by
simply tapping the ‘key’ icon while connected to the IP Doorbell
through the ControlCam App (no unlock code required). *Note: This
feature is currently not available on the iOS version of the ControlCam
App.
o Outdoor Call-in: To be able to receive a notification and ringtone of an
incoming call from the IP Doorbell the ‘Outdoor call-in’ must be
enabled or turned on. With this feature turned off, the IP Doorbell can
still be monitored by the ControlCam App but no notifications will be
sent to that specific mobile device. *Note: Outdoor call-in must be
turned off to be able to ‘Edit’ IP Doorbell settings in the ControlCam
App.
Deleting an IP Doorbell from your Mobile Device
- From the ‘Devices’ page in your ControlCam App, tap on the ‘…’ icon beside
the image of the IP Doorbell you wish to delete. Turn off the ‘Outdoor Call-in’,
and then tap ‘Edit’. Tap the red ‘Delete’ bar. Tap ‘OK’ to confirm.