User Manual

1. Installation
*Note: It may be more convenient to perform the initial configuration of the IP Doorbell
with it temporarily connected to power nearby your home internet router and a computer.
This way testing and operation can be verified before the unit is mounted permanently.
- Location: Choose a location for your new IP Doorbell, taking in to consideration
sightlines, shadows, and excessive background lighting for the camera. You must
also consider proximity to AC power and the ability to run wiring for additional
optional accessories. Optimal mounting height would be approximately 60”
(150cm) up from the surface that the caller is standing on. Consider drilling a 1¼”
diameter or larger hole into the wall behind the IP Doorbell to allow for the
concealment of the Wi-Fi antenna or RJ-45 Dongle within the wall.
- Back Box Mounting: Feed the power supply wiring, wiring harness(s), and the Wi-
Fi Antenna cable or the RJ-45 dongle through the hole from the back side of the
back box. Use the four screws (and anchors, if required) supplied to mount the
back box to the wall in the desired location.
- Connect wiring harness and other connections to the back of the IP Doorbell.
Gently feed excess wiring through the hole in the back box into the wall cavity,
and place the IP Doorbell into the back box (top first).
- Secure the IP Doorbell into the back box at the bottom leading edge using the two
supplied Hex-Head screws and Allen key.
2. Configuration
Begin by performing a factory reset of the settings in your IP Doorbell. To default the
settings to factory, follow these steps;
- Apply power to the IP doorbell.
- Within 5 seconds, press and hold the ‘Bell’ button until your hear a distinctive 1
second long buzzer sound (after approximately 1 minute, it is preceded by a flash
of the illuminator LED’s). Release the ‘Bell’ button after the buzzer sound stops.
- The IP Doorbell will reset once again (about one minute) and is ready to start
configuration shortly after the illuminator LED’s flash.
*Note: Performing a factory reset erases settings stored during the configuration process.
Do not perform a factory reset after you have configured the IP Doorbell unless absolutely
necessary.
*To Proceed with a Wireless (Wi-Fi) installation, go to step 3a.
*To Proceed with a Wired (RJ45) installation, complete step 3a, then connect the RJ45
cable.
*To Proceed with a Wired (RJ45) installation without any requirement for a Wi-Fi
connection credentials, start at step 3b (advanced).