User Manual

3a. Initial Wireless (Wi-Fi) and Wired (RJ45)
Configuration
*Note: The Wi-Fi radio in the IP Doorbell uses 2.4GHz only, and good Wi-Fi signal
operation at the IP Doorbell location is a must for satisfactory operation. Network speeds
through your LAN and over WAN (internet, Wide Area Network) must meet at least 300
Kbps upload speed (most ISP’s limit the upload speed much more than the download).
*Initial Wi-Fi Configuration should only be performed ONCE using the ControlCam App
on any mobile device. Additional mobile devices will use ‘Add a Network Device’ to add
the IP Doorbell to their ControlCam App.
Using an iOS Device:
- While in close proximity to your IP Doorbell, connect your iOS device to the Wi-
Fi network of the IP Doorbell (Device). The SSID will be similar to
‘LIDaw********’, or the GID of the IP Doorbell prefaced by ‘LID’.
- Open the ControlCam App.
- Tap ‘Add a New Device’.
- Tap on ‘Start configuring’.
- Select the Wi-Fi network on which you want to connect the IP Doorbell.
- Enter the Wi-Fi password for your selected network.
- Tap ‘Setting’ to save.
- IP Doorbell will restart to join the Wi-Fi network (about 1 minute) and your screen
will switch to the device settings page.
*Note: There is no indication of an incorrectly entered Wi-Fi password. An incorrect
password will cause the IP Doorbell to fail to connect to your Wi-Fi network, after
which it will reset once more and the ‘LIDaw********’ SSID will reappear in your
WiFi network scans on your mobile devices. If this happens, delete the IP Doorbell
from the ControlCam App and start at the beginning of section 3.a again.
- Enter a name in ‘Device Name’ that you want to use to define this specific IP
Doorbell (e.g. Front Door). This name will show in the ControlCam notifications
to your mobile device. *You may use spaces or other special characters in the
name, but only on iOS devices.
- Enter the ‘User Name’ (default is ‘admin’).
- Enter the ‘Password’ (default is ‘1234’).
- Tap ‘Done’.
- Re-enter the device settings and turn on the ‘Outdoor call-in’.
- *After correct configuration it may take a few moments for the IP Doorbell to
make the initial connection through the cloud service.
- *Unlock Password can be changed in the App as well as through the Web Browser
Interface.