User Manual

your router (consult the instructions for your individual router), or by using a
network scanning tool (e.g. Fing)
- Enter the IP address of the IP Doorbell into the address bar of your browser,
preceded by http:// (e.g. http://192.168.1.88 ).
- Hit enter and a login request should appear. There may also be requests to install
additional files, but if you are only intending to change the Network Configuration
then you can ignore these additional requests.
- Enter the ‘User Name’ (default is ‘admin’).
- Enter the ‘Password’ (default is ‘1234’).
- Click ‘Login’.
- Click ‘Config’ tab.
- Expand ‘Network Settings’.
- Click ‘Wireless’.
- Change ‘AP Mode’ to ‘WLAN Mode’.
- Click ‘OK’ to save the setting and restart the IP Doorbell.
- After the IP Doorbell finishes it’s reset (just after the illuminator LED’s flash,
about 1 minute), log back in to the Web Browser interface again.
- Click ‘Config’ tab.
- Expand ‘Network Settings’.
- Click ‘LAN’.
- Ensure that the Gateway IP address matches the IP address of your router.
4. Adding Mobile Devices
After successful completion of steps 3a or 3b above, Mobile devices will use ‘Add a
Network Device’ to add the IP Doorbell to their ControlCam App.
iOS Devices:
- Download and/or open the ‘ControlCam’ App.
- Tap on ‘Enter Now’ *Note: Do not tap ‘Add a New Device’.
- Tap ‘Add a Device’.
- Tap ‘Add a Network Device’ *Note: Do not tap ‘Add a New Device’.
- You now have 3 options for adding the IP Doorbell.
o 1. Local Search
 If your mobile device is on the same network as your IP Doorbell,
you can tap ‘LAN Search’ and a list of GID’s of IP Doorbells
installed on your network will display.
 Choose the GID of the IP Doorbell you want to add. GID’s in
yellow have already been added to this instance of the ControlCam
App.