User Manual

o Press ‘*’ to exit the programming mode.
- Add User Access Codes
o Enter programming mode.
o Enter 2 digits (10 – 40) representing the slot in which the user code will
reside, a longer beep is heard.
o Enter the new user code (length determined by other programming);
another longer beep will indicate the new code was stored successfully.
o Press ‘*’ to exit the programming mode.
o *Note: Slots 31 – 40 are not affected by the programmed unlock duration
time. These access codes will only trip the relay for about 1 second.
- Delete User Access Codes
o Enter programming mode.
o Enter 2 digits (01 – 40) representing the slot containing the access code you
want to delete. A longer beep is heard.
o Press the ‘#’ button, another longer beep is heard confirming deletion.
o Press ‘*’ to exit the programming mode.
- Delete User Access Codes Directly
o Enter programming mode.
o Press ‘#’, two short chirps are heard.
o Enter the access code you want deleted, a longer beep is heard confirming
deletion of the access code.
o Press ‘*’ to exit the programming mode.
- Setting the Length of the Access codes and Programming Password
o Enter the programming mode.
o Press ‘99’, a longer beep is heard.
o Enter a single digit (2 – 6) representing the desired length of the access
codes and programming password, a longer beep is heard confirming the
change.
o Press ‘*’ to exit the programming mode.