Manualshelf

User Manual

ManualsBrandsGBF ManualsElectronicsGlobal Wireless Video Door Phone & Doorbell WI-FI Intercom System Night Vision Weatherproof
12345678910
- Delete All Settings (Maintains Programming Password)
o Enter programming mode.
o Press ‘#’, two short chirps can be heard.
o Press’#’ again, a longer beep can be heard.
o Press ‘#’ again 7 more times. After 3 seconds another longer beep will be
heard confirming deletion of all User codes and resetting the unlock
duration time back to 1 second. Programming password and length will
remain unchanged.
o Press’*’ to exit the programming mode.
- Factory Reset (Custom Keypad Settings Only)
o Disconnect power to the IP Doorbell.
o While pressing the ‘#’ button, restore the power to the IP Doorbell. Two
short chirps will be heard.
o Continue holding the button until the IP Doorbell starts chirping
continuously. Release the button. A longer beep is heard, indicating the
keypad programming has been restored to factory default settings.
6. Advanced Features
There are a number of advanced features that can be configured in your IP Doorbell.
Access to these features requires accessing the IP Doorbell Web Server through Internet
Explorer (IE) using ActiveX controls. Many features will not be visible or configurable
with other web browsers. Video Tutorials and instructions for these features can be
downloaded from our website at www.gbfelectronics.com.
7. Using the ControlCam App
Receiving a Call from the Outdoor Station
- When a visitor pushes the ‘Bell’ button of the IP Doorbell, your mobile device
will receive a pop-up alert with an audible ringtone.
- Press ‘Accept’ to immediately open the ControlCam App and begin a video
conversation with the caller, or ‘Cancel’ if desired.
- Press and hold the ‘mic’ icon in the App to talk to your visitor. Release to listen.
*Network transmission delay may require you to hold the ‘mic’ icon pressed
for a slightly longer time to ensure your voice does not get cut short.
- To hear audio from the IP Doorbell, the ‘headphones’ icon must be highlighted
in orange (tap to change).
- The smaller ‘mic’ icon must be highlighted in orange (tap to change) to enable
the push-to-talk function of the larger ‘mic’ icon.