User's Manual

5-2
Software Installation
The software required to set up your Windows NT 4.0 computer is located on
the Elite 21 Series CD-ROM.
Windows NT 4.0 uses a Wizard to help you install printer software. A Wizard is
a series of dialog boxes. In each dialog box you make configuration choices
then click the Next button to move to the next dialog box.
Part of the software you will need is contained on the Windows NT 4.0 CD-
ROM. Please have this software available when doing the installation.
Note: These instructions cover installing the Elite 21 as a local printer
(connected via a parallel or serial port) on a Windows NT 4.0 workstation or
server.
If installing the printer as a stand-alone Ethernet device on a Windows NT
network, we recommend following these instructions as if the printer were being
installed as a local device on LPT1:. Once the installation is complete, proceed
to the Windows NT 4.0 section of Chapter 7 of this manual (Networking the Elite
21 Printer) for instructions on setting up the printer as a TCP/IP network device.