User's Manual

6-9
6. Configuration (continued)
• Language*: Specifies the language used on the printer’s LCD display and
internal pages. Default is English, also available are French, Italian, German
and Spanish.
• Startup Page: Determines whether a startup page is generated when the
printer is powered on. Default is Enabled.
Note: Changes made to items marked with an asterisk (*) will not take effect
until the printer is restarted.
7. Input/Output
• I/O Timeout: Sets the amount of time that the printer will wait for more
information when communicating with the computer or network before
flushing the job and timing out. This value can be set from 1 to 300 seconds
in one second intervals. Default is 15 seconds.
• TCP/IP*: Sets the built-in TCP/IP protocol to Disabled or Enabled.
• Gateway Address*: Sets the printer’s TCP/IP Gateway Address (also called
Default Router). This item only appears if TCP/IP is Enabled. To set this
address, press Value to change each bank of numbers and press Select to
accept the change and move to the next bank of numbers. Press Select
again when all four numbers are set.
• Subnet Mask: Sets the printer’s TCP/IP Subnet Mask. This item only appears
if TCP/IP is Enabled. To set this address, press Value to change each bank of
numbers and press Select to accept the change and move to the next bank
of numbers. Press Select again when all four numbers are set.
• IP Address*: Sets the printer’s TCP/IP Address. This item only appears if
TCP/IP is Enabled. To set this address, press Value to change each bank of
numbers and press Select to accept the change and move to the next bank
of numbers. Press Select again when all four numbers are set.
• EtherTalk*: Sets the built-in EtherTalk (AppleTalk via Ethernet) protocol to
Disabled or Enabled.
• Zone Name 1: Displays the printer’s default AppleTalk zone, if specified. This
item only appears if EtherTalk is enabled.
• Zone Name 2: Displays the printer’s secondary AppleTalk zone, if specified.
This item only appears if EtherTalk is enabled.