User's Manual

B-2
Envelopes
Commercial #10: 4.125 x 9.5 (104.8 x 241.3 mm)
Monarch: 3.875 x 7.5 (98.4 x 190.5 mm)
DL: 4.33 x 8.66 in. (110 x 220 mm)
C5: 162 x 229 mm (6.38 x 9.02 in.)
Print alignment
Skew: The amount by which a supposedly horizontal printed line may vary from being parallel
with the edge of the paper. This assumes that vertical printed lines are also at an angle, so that
the entire image is printed correctly but slightly rotated on the page. Measured with a 190 mm
(7.48 inch) line.
Within 1.2 mm (0.047 inch) either up or down
Registration: The amount by which images appearing to left or right, or above or below
previously printed images. Images appear on the paper correctly printed and aligned, but not in
the same place. Measured at the mid-point of the side or top of the paper.
Within 2.0 mm (0.079 inch) lead edge
Within 2.5 mm (0.099 inch) side edge
Magnification: The amount by which a line can be greater or smaller than its nominal length.
Measured with a 240 mm (9.45 inch) vertical line and a 190 mm (7.48 inch) horizontal line.
These lines are centered on the page to avoid measuring parallelism errors.
Within 0.8 percent longer or shorter than its nominal length
Horizontal Accuracy (Parallelism): The amount by which the ends of two vertical and two
horizontal lines can be greater or farther apart than the other ends. Measured with vertical lines
of 234 mm (9.21 inch) and horizontal lines 190 mm (7.48 inch). These lines are arranged to form
a rectangle on the page.
Within 1.2 mm (0.047 inch) horizontal or vertical either way
Linearity: The amount that three straight lines (horizontal, vertical, and diagonal) can vary from
being truly straight. One end of each of the horizontal and vertical lines meet at a corner; the
diagonal line is at 45 degrees to the other two lines and passes close to the center of the paper.
The horizontal line is 190 mm (7.48 inch), the vertical line is 234 mm (9.21 inch), and the
diagonal line is 269 mm (10.6 inch). The amount is measured by the distance a line can vary
from the position of a true straight line.
Within 0.5 mm (0.02 inch) either side, horizontal and vertical lines
Within 1.2 mm (0.05 inch) either side, diagonal line
Vertical Accuracy (Verticality): The amount one end of a 114.5 mm (4.51 inch) vertical line can
vary from true perpendicular.
Within 0.8 mm (0.03 inch) either side of true vertical