User's Manual

1-37
4. This will expose the main controller board
of the printer. The two RAM SIMM slots are
to the right of the board. There are three
slots in this area of the board, the two slots
to the left are the RAM SIMM slots.
At least one of the SIMM slots should have
a RAM SIMM pre-installed. Depending on
the existing RAM configuration of the
printer, the other slot may or may not be
open.
5. If replacing existing memory with larger
capacity SIMMs, remove the existing
SIMM(s) as shown.
Install the new SIMM(s) by positioning the
SIMM into the slot at approximately a 45
degree angle with its notched end at the
top of the slot. Gently rotate the SIMM to
the right until it clicks into place under the
metal guide clips.
SIMM Slots