Installation Instructions

EXHAUST LENGTH CALCULATION
RIGID (Preferred)
3DUWVDUHDYDLODEOHIURP\RXUORFDOVHUYLFHRUJDQL]DWLRQ
:;;´;¶'XFW :;;(OERZ
:;;´;¶'XFW :;;$OXPLQXPKRRG
4
ALCOVE OR CLOSET INSTALLATION
• If your dryer is approved for installation in an alcove or
closet, it will be stated on a label on the dryer back. The
LQVWDOODWLRQPXVWFRQIRUPWRWKHIROORZLQJVSHFL¿FDWLRQV
WARNING
TO PREVENT LARGE
AMOUNTS OF LINT AND
MOISTURE FROM ACCUMULATING AND TO
MAINTAIN DRYER EFFICIENCY, THIS
MACHINE MUST BE EXHAUSTED OUTDOORS.
• Minimum clearances between dryer cabinet and
DGMDFHQWZDOOVRURWKHUVXUIDFHVDUH
0LQLPXPYHUWLFDOVSDFHIURPÀRRUWRRYHUKHDGFDELQHWV
FHLOLQJHWFLVLQ
• Closet doors must be louvered or otherwise ventilated
DQGPXVWFRQWDLQDWOHDVWVTXDUHLQFKHVRIRSHQDUHD
equally distributed. If the closet contains both a washer
DQGDGU\HUGRRUVPXVWFRQWDLQDWOHDVWVTXDUHLQFKHV
of open area equally distributed.
NOTE TO INSTALLER - AFTER INSTALLATION
CHECK THE FOLLOWING:
(;+$867'8&70XVWPHHWVSHFVRQSDJH1R
H[FHVVLYHWXUQV1RNLQNVRUREVWUXFWLRQVWRDLUÀRZ
(;+$867+22'6KRXOGZRUNIUHHO\DQGRSHQGRZQZDUG
*5281',1*'U\HUPXVWEHSURSHUO\JURXQGHGWRFRQIRUP
to local codes and ordinance requirements.
23(5$7,217XUQGU\HURQDQGFKHFNIRUKHDW
+$1'&86720(57+(2:1(5¶60$18$/*LYH
LQVWUXFWLRQVRQRSHUDWLQJWKHGU\HU$QVZHUDQ\TXHVWLRQV

*,9(7+(6(,167$//$7,21,16758&7,216WRWKHFXVWRPHU
4" DIA.
4"
4" DIA.
2-1/2"
RECOMMENDED MAXIMUM LENGTH
Exhaust Hood Types
Recommended
No. of 90°
Elbows
Rigid
Metal
Rigid
Metal
14 m (46 ft)
11 m (37 ft)
9 m (30 ft)
7 m (23 ft)
11 m (37 ft)
9 m (30 ft)
6.5 m (22 ft)
4.5 m (15 ft)
0
1
2
3
Use only for short
run installations
CONNECTING THE DRYER TO HOUSE VENT
RIGID METAL TRANSITION DUCT
• For best drying performance, a rigid metal transition duct
is recommended.
• Rigid metal transition ducts reduce the risk of crushing
and kinking.
UL-LISTED FLEXIBLE METAL (SEMI-RIGID) TRANSITION
DUCT
,IULJLGPHWDOGXFWFDQQRWEHXVHGWKHQ8/OLVWHGÀH[LEOH
PHWDOVHPLULJLGGXFWLQJFDQEHXVHG.LW:;;
1HYHULQVWDOOÀH[LEOHPHWDOGXFWLQZDOOVFHLOLQJVÀRRUVRU
other enclosed spaces.
 7RWDO OHQJWK RI ÀH[LEOH PHWDO GXFW VKRXOG QRW H[FHHG 
feet.
• For many applications, installing elbows at both the dryer
DQG WKH ZDOO LV KLJKO\ UHFRPPHQGHG VHH LOOXVWUDWLRQV
EHORZ (OERZV DOORZ WKH GU\HU WR VLW FORVH WR WKH ZDOO
without kinking and or crushing the transition duct,
maximizing drying performance.
• Avoid resting the duct on sharp objects.
UL-LISTED FLEXIBLE METAL (FOIL-TYPE) TRANSITION
DUCT
• In special installations, it may be necessary to connect the
GU\HU WR WKH KRXVH YHQW XVLQJ D ÀH[LEOH PHWDO IRLO W\SH
GXFW $ 8/OLVWHG ÀH[LEOH PHWDO IRLOW\SH GXFW PD\ EH
XVHG 21/< LQ LQVWDOODWLRQV ZKHUH ULJLG PHWDO RU ÀH[LEOH
PHWDOVHPLULJLGGXFWLQJFDQQRWEHXVHG$1'ZKHUHD´
diameter can be maintained throughout the entire length of
the transition duct.
,Q&DQDGDDQGWKH8QLWHG6WDWHVRQO\WKHÀH[LEOHPHWDO
IRLOW\SHGXFWVWKDWFRPSO\ZLWKWKH³2XWOLQHIRU&ORWKHV
'U\HU7UDQVLWLRQ'XFW6XEMHFW$´VKDOOEHXVHG
1HYHULQVWDOOÀH[LEOHPHWDOGXFWLQZDOOVFHLOLQJVÀRRUVRU
other enclosed spaces.
7RWDOOHQJWKRIÀH[LEOHPHWDOGXFWVKRXOGQRWH[FHHGIHHW
• Avoid resting the duct on sharp objects.
For best drying performance
6OLGHRQHHQGRIGXFWRYHUWKHFORWKHVGU\HURXWOHWSLSH
6HFXUHWKHGXFWZLWKDFODPS
:LWKWKHGU\HULQLWVSHUPDQHQWSRVLWLRQH[WHQGWKHGXFW
WRLWVIXOOOHQJWK$OORZ´RIGXFWWRRYHUODSWKHH[KDXVW
SLSH&XWRႇDQGUHPRYHH[FHVVGXFW.HHSWKHGXFWDV
VWUDLJKWDVSRVVLEOHIRUPD[LPXPDLUÀRZ
4. Secure the duct to the exhaust pipe with the other clamp.
NOTE: The clearances stated above are minimums.
Consideration must be given to the type accessory
NLWXVHGZLWKGU\HU5HIHUWRWKHVSHFL¿FNLW
instruction for details.
Alcove Closet
Sides 0” ´
Top ´ ´
Front ´
Rear ´ ´
WHEN INSTALLED IN MANUFACTURED (MOBILE) HOMES
Dryer must be exhausted to the outside. Exhaust MUST NOT be
terminated beneath mobile home. Exhaust material MUST NOT
support combustion. Installation MUST conform to Manufactured
+RPH&RQVWUXFWLRQ6DIHW\6WDQGDUG7LWOH&)53DUW
or when such standard is not applicable, the American National
6WDQGDUGRI0RELOH+RPHV$16,1)5$1R%)RU
electrical connection, see “Connecting dryer using 4 wire connection”.
USE OF CASTERS (120V PORTABLE MODELS ONLY)
For a portable installation screw casters into the holes on the bottom
of the dryer. Refer to the “Installation Instructions for caster assembly”
sheet to install casters.
• )RU HYHU\ H[WUD  HOERZ UHGXFH WKH DOORZDEOH YHQW V\VWHP
OHQJWKE\IW
• 7ZRHOERZVZLOOEHWUHDWHGOLNHRQHHOERZ
• )RUWKHVLGHH[KDXVWLQVWDOODWLRQVDGGRQHHOERZWRWKHFKDUW
• The total vent system length includes all the straight portions and
HOERZVRIWKHV\VWHPWUDQVLWLRQGXFWLQFOXGHG
FLEXIBLE
7RWDOOHQJWKRIÀH[LEOHPHWDOGXFWVKDOOQRWH[FHHGIWP7KH
IROORZLQJNLWLVDYDLODEOHIURP\RXORFDOVHUYLFHRUJDQL]DWLRQ
.LW :;;  ´ GLD ÀH[LEOH PHWDO VHPLULJLG 8/OLVWHG
WUDQVLWLRQGXFWLQFOXGHVHOERZV